Bedienungsanleitung NetBotz NBRK0550 (Seite 150 von 154) (Englisch)

646450

150

Zoom out

Zoom in

Vorherige Seite

1/154

Nächste Seite

141NetBotz Appliance User’s Guide

Solutions

If your appliance has become overloaded, the following configuration adjustments will help alleviate the

load on the appliance:

• If you are using the Scanned Devices functionality, increase the scan interval.

For information on the Scanned Devices functionality, see “Scanned Devices” on

page 44. For details on increasing the scan interval, see “Adding, editing, and

removing SNMP targets” on page 46.

• If you are using Scanners, disable MIB2 scanning on devices. Some devices (routers, for

example) can include many communications interfaces, and scanning all MIB2 interfaces on these

devices can cause delays on Scanners performance.

• Lower the Interactive Frame Rate Limit on some or all cameras connected to the appliance.

Lowering the Interactive Frame Rate Limit will improved performance issues caused by multiple

clients accessing the appliance interactively.

To change Interactive Frame Rate Limits, see “Settings” on page 36.

• If Camera Motion thresholds are enabled for alerting, check the following to ensure that

thresholds and settings are not causing camera motion to be detected continuously:

– Check that the Sensitivity and Area of Motion settings are appropriate for your environment

and the type of motion you want to detect.

– If there are areas of an image that you don't need to detect motion, mask those areas.

To set up a mask, see “Mask settings” on page 41.

– If Camera Motion thresholds (or any other thresholds that include camera images) are

generated frequently, adjust the thresholds to make them less sensitive. You can also use Alert

State for Time alert types instead of Alert State alert types to minimize duplicate event

notifications.

– If there are time periods where you want to ignore motion events, use the Advanced

Scheduling option within the Camera Motion threshold to disable the sensor for specific time

periods.

• Reduce the capture size of pictures being collected by your camera pods.

• If you have several busy camera pods connected to one appliance and have multiple appliances

available, distribute the cameras to the other appliances to even out the image capture load.

• Spread out the initialization of alert notifications over the span of a few minutes by using multiple

alert levels in the Alert Profile.

• Overall Alert Load: If your appliance is detecting more than a couple of alert events every few

minutes, you may need to re-evaluate your alert threshold settings. If you have several alert

actions configured that are running on short intervals, consider breaking those out into longer

intervals or creating multiple profiles that can be customized for different sensor types. This

allows sensors which collect picture captures to have notifications sent on different intervals (and

with different alert actions) than other sensors which might not require picture captures.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

NetBotz NBRK0550 Seite 150

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info