Bedienungsanleitung NetBotz NBWL0455 (Seite 99 von 154) (Englisch)

646452

Zoom out

Zoom in

Vorherige Seite

1/154

Nächste Seite

90NetBotz Appliance User’s Guide

The following controls appear in the Advanced tab:

Use the Status tab to view the status of your PPP connection, or to request an immediate dial-out to

establish a PPP connection if none exists. Click Request Immediate Dial-Out to establish a connection.

Once initiated, the PPP connection stays active until you click Cancel Dial-Up Request or the appliance

reboots.

Dial-out response to alerts/reports Select the PPP dial-up action taken by the appliance when alerts or

periodic reports are generated. Select from the following list:

• Disabled—No dial-up action is taken when alerts or reports are

generated.

• Enabled—Use PPP to connect to the network whenever an alert or

report is generated. Note: If the alert does not require a PPP

connection, no connection will be made.

• Delivery Failure—Use PPP to connect to the network only if

network-based alert notification (for example, e-mail, FTP, HTTP

posting) or report delivery fails.

Remain connected after alerts/

reports sent

The number of minutes the appliance keeps the PPP connection active

after connecting to the network to deliver alert or report information.

Field Description

LCP - Send LCP echo requests to

peer

When checked, your appliance sends LCP echo requests, telling PPP

that the PPP link is active even when there is no network traffic.

Exclusive route - Route all data

through PPP when dialed-out

If selected, all data is routed through the PPP interface during PPP

dial-out sessions.

When cleared, the Ethernet interface communicates with hosts on the

same subnet as the appliance. All communication with hosts that are not

on the same subnet as the appliance uses the PPP interface.

Debug - Send debug messages to

syslog

When selected, debug messages are forwarded to the Syslog host

specified using the Log icon.

For more information, see “Log” on page 86.

SIM PIN / Confirm SIM PIN For modems that use a subscriber identification module (SIM), specify

the PIN used to unlock the SIM.

NOTE: A SIM may not require a PIN. For modems that do not have a

SIM, this field must be blank.

Extra Initialization Commands If necessary, type additional initialization commands to append to the

commands noted in the Initialization commands field.

Use default modem commands Select to use the default modem initialization string for your modem.

Initialization commands If necessary, edit the initialization string for your modem.

E-mail Addresses for IP address

Notification

When a PPP connection is established, an e-mail containing the IP

address of the appliance is sent to all e-mail addresses in this field. To

add addresses to this field, click Add, type an address in the E-mail

Address field, and click OK.

Field Description

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

NetBotz NBWL0455 Seite 99

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info