Bedienungsanleitung Netgear D6200 (Seite 141 von 162) (Englisch)

519533

141

Zoom out

Zoom in

Vorherige Seite

1/162

Nächste Seite

Advanced Settings

141

D6200 WiFi DSL Modem Router

The remote VPN endpoint must have this VPN gateway’s address entered as its

remote VPN endpoint.

• Local LAN. These settings identify which computers on your LAN are covered by this

policy. For each selection, data must be provided as follows:

- Single address. Enter an IP address in the Single/Start IP address field.

Typically, this setting is used when you wish to make a single server on your LAN

available to remote users.

- Range address. Enter the starting IP address in the Single/Start IP address field,

and the finish IP address in the Finish IP address field. This setting must be an

address range used on your LAN.

- Subnet address. Enter an IP address in the Single/Start IP address field, and the

desired network mask in the Subnet Mask field.

The remote VPN endpoint must have these IP addresses entered as its remote

addresses.

• Remote LAN. These identify which computers on the remote LAN are covered by this

policy. For each selection, data must be provided as follows:

- Single PC - dynamic IP. Select this option if there is no LAN (only a single

computer) at the remote endpoint. If this option is selected, no additional data is

required.

- Single address. Enter an IP address in the Single/Start IP address field. This

setting must be an address on the remote LAN. Typically, this setting is used

when you wish to access a server on the remote LAN.

- Range address. Enter the starting IP address in the Single/Start IP address field,

and the finish IP address in the Finish IP address field. This range must be an

address range used on the remote LAN.

- Subnet address. Enter an IP address in the Single/Start IP address field, and the

desired network mask in the Subnet Mask field.

The remote VPN endpoint must have these IP addresses entered as its local

addresses.

• ESP Configuration. ESP (encapsulating security payload) provides security for the

payload (data) sent through the VPN tunnel.

- SPI. Enter the required SPIs. Each policy must have unique SPIs. These settings

must match those for the remote VPN endpoint. The Incoming setting here must

match the Outgoing setting on the remote VPN endpoint, and the Outgoing setting

here must match the Incoming setting on the remote VPN endpoint.

- Encryption. Select the desired encryption algorithm, and enter the key in the field

provided. For 3DES, the keys should be 24 ASCII characters (48 hex characters).

- Authentication. Select the desired authentication algorithm, and enter the key in

the field provided. For MD5, the keys should be 16 ASCII characters (32 hex

characters). For SHA-1, the keys should be 20 ASCII (40 hex characters).

4. Click Apply.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Netgear D6200 Seite 141

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Netgear D6200

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info