Bedienungsanleitung Netgear WG102-500 (Seite 114 von 134) (Englisch)

519681

114

Zoom out

Zoom in

Vorherige Seite

1/134

Nächste Seite

114 |

WG102-500, WGAP150 ProSafe™ 802.11g Wireless Access Point

• If you are using the NetBIOS name of the wireless access point to connect, ensure that

your computer and the wireless access point are on the same network segment or that

there is a WINS server on your network.

• If your computer uses a fixed (static) IP address, ensure that it is using an IP address in

the range of the wireless access point. The wireless access point default IP address is

192.168.0.229 and the default subnet mask is 255.255.255.0.

• Make sure that your browser has Java, JavaScript, or ActiveX enabled. If you are using

Internet Explorer, click Refresh to be sure that the Java applet is loaded.

• Try quitting the browser and launching it again.

• Make sure that you are using the correct login information. The factory default login name

is admin, and the password is password. Make sure that Caps Lock is off when entering

this information.

If the wireless access point does not save changes you have made in the Web configuration

interface, check the following:

• When entering configuration settings, be sure to click the Save or Save to Flash &

Activate button before moving to another screen or tab, or your changes are lost.

• Click the Refresh or Reload button in the Web browser. The changes might have

occurred, but the Web browser might be caching the old configuration.

When You Enter a URL or IP Address a Time-out Error

Occurs

A number of things could be causing this. Try the following troubleshooting steps.

• Check whether other computers on the LAN work properly. If they do, ensure that your

computer’s TCP/IP settings are correct. If you use a fixed (static) IP address, check the

subnet mask, default gateway, DNS, and IP addresses of the wireless access point (see

“Configuring IP Settings” on page 20).

• If the computer is configured correctly, but still not working, ensure that the wireless

access point is connected and turned on. Connect to it and check its settings. If you

cannot connect to the wireless access point, check the LAN and power connections, and

check the Web management settings of the wireless access point (see

“Disabling Web

Management Access Entirely” on page 81, “Configuring Web Management Access” on

page 78, and “Disabling Web Management Access from Wireless Clients” on page 80).

• If the wireless access point is configured correctly, check your Internet connection (for

example, your cable modem) to make sure that it is working correctly.

Troubleshooting a TCP/IP Network Using the Ping Utility

Most TCP/IP terminal devices and routers contain a ping utility that sends an echo request

packet to the designated device. The device then responds with an echo reply.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Netgear WG102-500 Seite 114

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Netgear WG102-500

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info