Bedienungsanleitung Netgear XWN5001 Powerline 500 WiFi Access Point (Seite 44 von 48) (Englisch)

608404

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

Notification of Compliance

Powerline 500 WiFi Access Point (XWN5001)

The voltage and current rating of the cable should be greater than the ratings marked on

the product.

• To help prevent electric shock, plug the system and peripheral power cables into properly

grounded electrical outlets.

• Do not use adapter plugs. If you must use an extension cable, use a three-wire cable with

properly grounded plugs.

• Observe extension cable and power strip ratings. Make sure that the total ampere rating f

all products plugged into the extension cable or power strip does not exceed 80 percent

of the ampere ratings limit for the extension cable or power strip.

• To help protect your system from sudden, transient increases and decreases in electrical

power, use a surge suppressor, line conditioner, or uninterruptible power supply (UPS).

• Position system cables and power cables carefully; route cables so that they cannot be

stepped on or tripped over. Be sure that nothing rests on any cables.

• Do not modify power cables or plugs.

• Always follow your local and national wiring rules.

Regulatory Compliance Information

FCC Requirements for Operation in the United States

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired operation.

FCC Declaration Of Conformity

We, NETGEAR, Inc., 350 East Plumeria Drive, San Jose, CA 95134, declare under our sole

responsibility that the Powerline 500 Access Point (XWN5001) complies with Part 15 of FCC

Rules. Operation is subject to the following two conditions:

• This device may not cause harmful interference, and

• This device must accept any interference received, including interference that may cause

undesired operation.

FCC Radio Frequency Interference Warnings & Instructions

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following methods:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Netgear XWN5001 Powerline 500 WiFi Access Point Seite 44

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info