Bedienungsanleitung Nextbase in-Car Cam 402G Professional (Seite 20 von 40) (Deutsch, Englisch)

570051

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

TROUBLE SHOOTING (CONTD.)

My iN-CAR CAM shuts down by

itself after a while.

No power to my iN-CAR CAM,

but it works upon my PC.

The SD card in my iN-CAR CAM

can not be read.

I can't delete files on my SD card

within the iN-CAR CAM.

The screen blanks after a few

minutes upon my iN-CAR CAM.

I get the message “Cluster Wrong”

on screen.

The Driving Recorder Player will

not open.

The iN-CAR CAM can not lock

onto satellite

I have turned on ‘motion detection’

and now can’t stop the recording.

The battery will not charge.

The battery only last 30 seconds

The battery only lasts 6 minutes.

Either the battery has gone flat, or there is no power to the iN-CAR CAM

and the AutoPower Off period (which is in the SETUP menu) has been

triggered.

The cigarette power cable is not working. Inspect the fuse in the Car Power

plug. Replacement fuse = 2A 20mm type. If the fuse if found to be blown,

inspect the power cable for damage which may have caused the fuse blow.

Use a good quality branded SD card between 4GB and 32GB (suggested)

and format the card from with in the SETUP menu of the iN-CAR CAM.

Check to see if these files are 'protected', if so please follow instructions

to 'un-protect'

The screen saver is set to ON. Change settings to OFF if required.

Default setting is off.

The SD card has been formatted in another device and the Cluster Size is

not compatible. Simply use the MENU, SETUP option to re-format the SD

card from within the iN-CAR CAM.

For Windows operating systems the player requires an internet connection

to open, if this is not available please view files using alternative playback

software, i.e. QuickTime or VLC.

After power on and with the device mounted with clear view of the sky it can

take up to 10 minutes to find the three satellites required to achieve a stable

signal. Reception can also be affected by atmospheric conditions and the

proximity of buildings / trees obscuring the sky.

The iN-CAR CAM will start a recording whenever motion is detected, when

function is to be turned off firstly shutdown the iN-CAR CAM and remove the

SD card, this will avoid recording being activated accidentally. Switch back

on the and within the setting menu and turn off the ‘Motion Detection’.

To protect from over-charging the battery will only charge when the

iN-CAR CAM is turned on.

The battery will only receive charge when the iN-CAR CAM is turned on,

please reconnect car adaptor and leave the iN-CAR CAM turned on.

Charging takes approximately 90 minutes and a full charge is indicated by

a red LED.

This is normal, the battery design allows the 'Auto Power Off' feature to

function in event of power loss within the vehicle. It is not intended as an

alternative power source to replace the supplied car adaptor.

English

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nextbase in-Car Cam 402G Professional Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Nextbase in-Car Cam 402G Professional

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info