Bedienungsanleitung Nikon Coolpix P1 (Seite 153 von 183) (Englisch)

102897

153

Zoom out

Zoom in

Vorherige Seite

1/183

Nächste Seite

141

Wireless Transfer Mode

If an Error Message Appears

When a profile cannot be selected (when trans-

mission has not started), “NETWORK CONNEC-

TION FAILED” is displayed. After WIRELESS

MENU is selected and camera cannot connect to

profile device, “Failed to connect to XXX” is dis-

played. Check the selected computer or access

point and fix the cause of the error. Highlight

Try Again and press d to reconnect. Select

Choose Profile to cancel the connection and return to the CHOOSE PROFILE screen. If Try

again cannot be selected due to the source of the error, select Choose Profile.

Wireless Transfer LED

The wireless transfer LED (in the antenna on the side of the camera) indicates the wireless

transfer status as shown below.

Blinks : Searching for profile device.

Lights: Connected to profile device or transferring data.

Off : Not connected.

In order to reduce power consumption, the wireless transfer LED may switch to blinking sta-

tus if no data is transferred within a set period of time based on operating conditions.

Notes on Wireless Transfer Mode

• If no operations are performed for approximately three minutes, the camera will enter

Standby mode and the monitor will turn off automatically. The camera will enter Standby

mode even during transfer but transfer will continue.

• Video output is not available in Wireless transfer mode.

Resuming Cancelled Transfer Operations

If the transferring of images by wireless LAN connection is interrupted due to a weak signal

or low battery, the images can be resent. Select Yes when the message “Resume interrupted

transfer?” is displayed while Wireless transfer mode is enabled. Transferring is resumed for

those images that could not be transferred. Select No to cancel transfer operations.

d Button

In Wireless transfer mode, the d button on the camera is used only to perform menu oper-

ations. Pressing the d button does not transfer images with E (transfer mark), unlike

when using PictureProject via a USB connection (c61). See the procedures on pages 140 to

147 for more information on transferring images using Wireless transfer mode.

Memory Card Write Protection

When the memory card switch is in the “Lock“ position, images cannot be transferred. Slide

the switch to the “Write“ position before transferring images.

Optional Wireless Printer Adapter Connection Configuration

When the m button is pressed in the CHOOSE PROFILE screen, the optional PD-10 wireless

printer adapter can be selected as a profile. See the manual of the wireless printer adapter

for details on the wireless printer adapter.

NETWORK CONNECTION

FAILED

Choose Profile

Try Again

Confirm

Failed to connect to

Profile-A

Choose Profile

Try Again

Confirm

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nikon Coolpix P1 Seite 153

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Nikon Coolpix P1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info