570908
78
Zoom out
Zoom in
Vorherige Seite
1/112
Nächste Seite
70
Problem Possible Cause
24
24
23
148
5
A–2
A–2
25
148
Your computer does not rec-
ognize the scanner
The scanner is off
Turn the scanner on.
The scanner was turned on with the FH-3 film holder
inserted in the adapter slot
After removing the FH-3, turn the scanner off and then on
again.
The interface cable is not properly connected
After confirming that the scanner is off, reconnect the ca-
ble.
Another device or program using the same interface
conflicts with the scanner or Nikon Scan
Remove all other hardware connected to the same bus as
the scanner. If the scanner is connected to a hub, exten-
sion cable, or other adapter, disconnect the adapter and
connect the scanner directly to the computer. If this does
not solve the problem, uninstall other software that uses
the same interface and re-install Nikon Scan.
Your computer system does not meet the minimum
system requirements
See the Nikon Scan 3 Reference Manual for more informa-
tion on system requirements.
The interface board is not compatible with Nikon Scan
If you are using the 4000 ED, check the compatiblity infor-
mation provided with your scanner to determine whether
the IEEE 1394/Firewire board you are using is compatible
with Nikon Scan (if you are using Windows computer with
a built-in IEEE 1394 port, check the make and model num-
ber of your computer). Updated compatiblity information
may also be available on the Nikon support web site for
your area. If your IEEE 1394/Firewire board is not compat-
ible with Nikon Scan, install the REX-PFW2W IEEE 1394
interface board included with your scanner (desktop com-
puters) or purchase one of the recommended PCMCIA
interface cards (laptop computers). Note that the
COOLSCAN IV ED will only function with built-in USB
ports.
The interface board is not correctly installed
Check the documentation for your IEEE 1394 or Firewire
interface board.
The device driver for your scanner is missing or cor-
rupted (Windows only)
Check that the driver is correctly installed
Nikon Scan is not correctly installed
Uninstall and re-install the software.
78

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Nikon Coolscan IV ED wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Nikon Coolscan IV ED

Nikon Coolscan IV ED Bedienungsanleitung - Deutsch - 112 seiten

Nikon Coolscan IV ED Bedienungsanleitung - Holländisch - 112 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info