Bedienungsanleitung Nikon Coolshot 40 (Seite 6 von 31) (Englisch, Französisch, Portugiesisch, Spanisch)

604465

Zoom out

Zoom in

Vorherige Seite

1/31

Nächste Seite

10 11

5. Internal display

: Aim at the target you want to measure.

Position the target at the center of the reticle.

: Now measuring

* Because the internal display of this product is enlarged by the eyepiece, dust may sometimes be seen.

This will not, however, affect the measurement accuracy.

8. Battery

1. Type of battery

3V CR2 lithium battery x1

2. Inserting/replacing battery

2-1. Open the battery chamber cover

Rotate the battery chamber cover counterclockwise and remove it. It may not open easily due to its rubber

packing for water resistance.

2-2. Insert the battery/Replace the old battery with a new one

Insert a new battery correctly positioned following the indication seal inside the chamber. The [+] pole should be

positioned toward the inside of the chamber. If the battery is not inserted correctly, the Nikon Laser Rangefinder

will not operate. When replacing the battery, remove the old battery then insert a new one.

2-3. Close the battery chamber cover

Rotate the battery chamber cover clockwise to screw it into the body. It may not close easily due to the rubber

packing for water resistance, but continue to turn it all the way until it stops. Confirm that the cover is securely

closed.

3. Battery level indicator

* The battery condition mark in the internal display warns when the battery needs to be replaced.

Display Description

After power on, displays for 2 seconds only.

Sufficient power available.

After power on, displays for 2 seconds only.

Power getting low.

Prepare to replace the battery.

Displayed continuously.

Low. Battery should be replaced with a new one.

Blinks. After blinking 3 times, automatically

powers o.

Power exhausted.

Replace the battery.

4. Battery life

Continuous operation: Approx. 1,400 times (at approx. 20°C)

This figure may differ according to conditions, temperature, and other factors such as target shape, color, etc. Use only

as a guide.

* The battery supplied with this Nikon Laser Rangefinder is for operation checking. Due to natural electrical discharge, the life

of this battery will likely be shorter than that noted above.

* If water enters the battery chamber due to submersion, dry the battery chamber well, then replace the battery.

6. Target priority mode

This Nikon Laser Rangefinder employs First Target

Priority mode.

When measuring overlapping subjects, it displays the

distance of the closest subject.

7. Distance display units

Meter [ ]Yard

[ ]

Measurement results are displayed in yards/meters.

(Factory default setting is yard.)

1. Turn on the power.

2. Press and hold the MODE button for more than two

seconds. After the display unit has switched, release

the button.

Target mark

Distance

Unit of measure (m/yd.)

Laser irradiation mark

Battery condition

: Appears while the laser is being irradiated for

a measurement.

Do not look towards the objective lens side

while this mark is shown.

: "Failure to measure" or "Unable to measure"

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nikon Coolshot 40 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Nikon Coolshot 40

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info