Bedienungsanleitung Nikon Coolshot (Seite 17 von 139) (Alle Sprachen)

570991

Zoom out

Zoom in

Vorherige Seite

1/139

Nächste Seite

32 33

Others

This Nikon Laser Rangefinder is a basic rangefinder. Its results cannot be used as official evidence.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part

15 of the FCC Rules and to EU EMC directive. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

　• Reorient or relocate the receiving antenna.

　• Increase the separation between the equipment and receiver.

　• Consult the dealer or an experienced radio/TV technician for help.

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired operation.

Troubleshooting/Repair

If your Nikon Laser Rangefinder should require repair, please contact your local dealer for details regarding where to

send it. Before doing so, you are advised to consult the Troubleshooting Table below.

Symptom Check Points

Unit does not turn on — LCD fails to

illuminate

• Depress POWER button.

• Check battery insertion

• Replace the battery if necessary.

Target range cannot be obtained

• Be sure that nothing, such as your hand or finger, is blocking the laser

emission aperture and laser detector.

• Be sure that the laser emission aperture and laser detector are clean.

Clean them if necessary.

• Be sure that the target shape and condition are appropriate to reflect the

laser beam.

• Replace battery.

[- - -] (“Cannot measure”) appears

• Be sure to hold the unit steady while measuring.

• Be sure the target is within measuring range (10-550m/11-600 yards)

Closer target cannot be measured

• Be sure that nothing, such as leaves or grass, is between the Nikon Laser

Rangefinder and the target.

Target beyond a certain distance

cannot be measured

• Be sure that nothing, such as leaves or grass, is between the Nikon Laser

Rangefinder and the target.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nikon Coolshot Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info