Bedienungsanleitung Nikon F100 (Seite 18 von 57) (Englisch)

3280

Zoom out

Zoom in

Vorherige Seite

1/57

Nächste Seite

Film

• Setting and confirming film speed

Rotate the Main-Command Dial while pressing the film

speed ° button to set film speed in use.

• Film speed can be set to s and between ISO 6-6400 in 1/3 steps by rotating

the Main-Command Dial.

• When film speed is set to s and DX-coded film is installed, film speed is

automatically set between ISO 25-5000. Film speed can also be set manually

with DX-coded film to have an effect of increased or decreased film sensitivity.

• Film speed can be set between ISO 6-6400 with non-DX-coded film.

• Press the ° button to confirm the film speed set on the camera.

· 5: When film speed is set to s and non-DX-coded film is loaded, a, s

and Err blink in the LCD panel after film is advanced to the first frame. This

warning indication can be changed to appear when the power switch is turned

on (page 71).

• Mid-roll rewind

To rewind film at mid-roll, press the two film rewind

buttons „ simultaneously for approx. 1 sec.

• o–– blinks in the LCD panel during film rewind and the frame counter counts

backwards until rewind is complete.

• Film is completely rewound when the frame counter shows blinking “E”. (E

appears without blinking when the exposure meter is off.) Open the camera

back and remove the film cartridge.

• If film does not start to rewind or film rewind stops at mid-roll

• When battery power is very low, or at low temperatures, film may not start

rewinding or film rewind may stop at mid-roll, and o–– and frame number will

blink in the LCD panel. In this case, turn the power switch off, change

batteries, then turn the power switch on and rewind film again.

• Film advance mode

Rotate the film advance mode selector while pressing

the film advance mode selector lock release to select

film advance mode.

• The following film advance modes are available:

S: Single-frame shooting

Fully depressing the shutter release button takes one picture and

automatically advances the film by one frame.

C: Continuous shooting

Shots are taken continuously at the rate of up to approx. 4.5 fps as long

as you keep the shutter release button fully depressed.

Cs: Continuous silent-low-speed shooting

Shots are taken continuously at the rate of up to approx. 3 fps as long as

you keep the shutter release button fully depressed. Film rewind speed

also slows down and there is little rewind noise.

Film advance speed is tested using camera settings of focus mode C, exposure

mode ¢, shutter speed 1/250 sec. or faster, aperture other than maximum, at

normal temperature of 20°C (68°F), with AA-type alkaline-manganese batteries, for

the first to 36th frames of a film.

• When the film advance mode selector is set to Z, multiple exposure can be

performed (page 60). Also, when it is set to V, self-timer operation can be

performed (page 67).

• When the batteries are exhausted, film advance speed slows down since film

advance automatically switches to start after the mirror is all the way down.

(Normally, film advance starts immediately when the mirror starts to go down.)

In this case, battery change is recommended.

Film

P500 (E) 02.12.27 5:48 PM Page 34

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nikon F100 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Nikon F100

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info