Bedienungsanleitung Nikon F100 (Seite 50 von 57) (Englisch)

3280

Zoom out

Zoom in

Vorherige Seite

1/57

Nächste Seite

9998

TroubleshootingNotes on Batteries

• Use four AA-type alkaline-manganese or lithium batteries

Two 3V lithium batteries (CR123A or DL123A) can be used with optional 3V

Lithium Battery Holder MS-13. With Multi-Power High Speed Battery Pack

MB-15, six 1.5V alkaline-manganese or lithium batteries, or Ni-MH battery MN-15

can be used to power the F100.

• Change the batteries well before the end of their life and prepare spare batteries

before important photographic occasions.

• Turn the camera power off when changing batteries

Turn the camera power off before changing batteries and insert the batteries with

+ and – ends positioned correctly.

• Stains on the battery poles may cause lack of contact. Wipe the batteries well

with a dry cloth before installing.

• Use fresh batteries at low temperatures

Battery power diminishes at extremely low temperatures and the camera may not

function properly with old batteries. Use a fresh set of batteries at low

temperatures, keep spare batteries warm, and use them alternately.

• Film advance speed lowers and number of usable film roll becomes less at low

temperatures. However, battery power may recover when the temperature

returns to normal.

• Do not throw batteries into a fire or short circuit batteries

Do not throw batteries into a fire. Do not short, disassemble, heat or charge

batteries.

WARNING

Do not leave

Keep batteries out of children’s

reach.

If someone accidentally swallows batteries,

call a doctor immediately.

LCD panel Viewfinder

ƒEE blinks ƒEE blinks

M appears —

M blinks —

M and Err Err blinks

blink

ƒ-- appears ƒ-- appears

Err and E blink Err and

E blink

a, s, and Err blinks

Err blink

E blinks when E blinks when

exposure meter exposure meter

is turned on is turned on

End blinks End blinks

— ? blinks

Cause

• CPU Nikkor lens (other

than G-type) is not set

to its minimum

aperture.

• Batteries are nearing

exhaustion.

• Batteries are just about

exhausted.

• Batteries are

exhausted during film

rewind.

• Non-CPU lens is

attached or lens is not

attached.

• Film is not correctly

advanced.

• Film speed is set to DX

and non-DX-coded film

is loaded.

• Film remains in the

camera after film

rewind is complete.

• The end of the film roll

has been reached.

• Autofocus is not

possible.

Page

18, 32

21, 34

Remedy

• Set lens to minimum

aperture.

• Have fresh ones ready.

• Turn the power off and

replace batteries with

new ones.

• Replace batteries with

new ones or recharge

batteries and turn the

power on again. If this

warning appears

frequently, contact

authorized Nikon dealer

or service center.

• Attach CPU lens (except

IX-Nikkor). With a non-

CPU lens, set the

exposure mode to A or

M and set the aperture

with lens’ aperture ring.

• Reload film.

• Load DX-coded film or

set the film speed

manually.

• Remove the film

cartridge.

• Rewind film by

pressing the two film

rewind buttons „.

• Focus manually.

Miscellaneous

P500 (E) 02.12.27 5:48 PM Page 98

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nikon F100 Seite 50

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Nikon F100

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info