Bedienungsanleitung Nikon F70D (Seite 15 von 69) (Englisch)

570963

Zoom out

Zoom in

Vorherige Seite

1/69

Nächste Seite

2928

FILM ADVANCE MODE

There are four automatic film advance modes. Hold FUNCTION

button and rotate command dial until the Function Area

indicator appears in the Film Advance Mode Area and V, Z,

X or C blinks, then hold SET/! button and rotate command

dial until desired symbol appears. Set V for single-frame

shooting, X for continuous low-speed shooting, Z for

continuous high-speed shooting, or C for silent rewind, and so

on.

V Single-frame shooting and C silent rewind

Fully depressing shutter release button takes one picture and

automatically advances film by one frame. Film is advanced

immediately after shutter closes whether you remove your

finger from shutter release button or keep the button

depressed. To take the next shot, lift your finger from the

button, then fully depress it again.

C for silent rewind is for times when conditions require a

minimum of operating noise. You can rewind film very quietly.

X Continuous low-speed and Z continuous

high-speed shooting

Shots are taken continuously as long as you keep shutter

release button fully depressed. You have a choice of shooting

speeds: approx. 3.7 fps (frames per second) in the Z mode,

and approx. 2.0 fps in the X mode—with fresh lithium

batteries at normal temperature (20˚C) and at shutter speeds of

1/250 sec. or higher in the Manual exposure and Manual focus

modes. With shutter speeds slower than 1/250 sec., the

framing rate becomes progressively slower in proportion to the

shutter speed in use.

• When built-in flash is activated, continuous shooting is

automatically switched over to single-frame shooting (V). In

this case, Z or X blinks in LCD panel.

FOCUS AREA

The F70/F70D’s autofocus system offers a choice of two focus

areas: Wide and Spot.

While pressing focus area button, rotate command dial until the

desired symbol––< for Wide Area or > for Spot Area—

appears in LCD panel.

< Wide Area AF

The Wide-Area focus brackets delineate the focus detecting

area in the viewfinder. Subjects of sufficient brightness and

detail can be detected within these brackets. In addition to

general photography, autofocus using Wide-Area focus

brackets is suited to action photography in which the moving

subject requires a wide-range focus detection area.

However, focus detection may not be possible if the subject is

too small to fully cover the Wide-Area focus brackets. If various

subjects, each at a different distance, fall within the focus

detection area, focus will be confirmed for a single subject as

follows:

• For subjects of equal brightness: the closer one will be

focused.

• For subjects of unequal brightness: the brighter one will be

focused.

For flash photography

When built-in flash is activated or accessory Nikon

Speedlight is turned on, Wide Area is automatically

switched over to Spot Area. In this case, < blinks in

LCD panel and e appears inside viewfinder.

F70D I/MêÊçsâ¸í˘ 03.1.16 5:33 PM Page 28

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nikon F70D Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info