493169
24
Zoom out
Zoom in
Vorherige Seite
1/68
Nächste Seite
C365
10
11/2010
ATTIX 115-01 / ATTIX 125-01
GB
Absolute lter assembly or replacement
WARNING!
Do not use the absolute lter again after having
removed it from the vacuum cleaner.
Figure 9
1. Vacuuming unit
2. Closing band
3. Filter shaker stop
4. Filter shaker knob
5. Washer
6. Ferrule
7. Absolute lter
8. Seal
9. Disc
10. Nut
WARNING!
Reassemble with care to avoid trapping your hands
between the vacuum unit and the container. Use
gloves that provide protection against mechanical
risks (EN 388) with a level of protection CAT. II.
Before proceeding with these operations, turn the vacuum
cleaner off and disconnect the plug from the power socket.
Assembly
1. Release the stop (3) and unscrew the lter shaker knob
(4), release the closing band (2) and remove the head
(1).
2. Unscrew the nut from the ferrule under the head (1),
insert the washer (5), screw the ferrule (6), insert the
lter (7), the gasket (8) and the disc (9), screw the nut
(10), t the head back in position and x with the closing
band (2), screw the knob (4) and lock it with the stop (3).
Replacement
1. Proceed as indicated in step 1 of the assembling
procedure.
2. Unscrew the nut (10), remove the disc (9) and the gasket
(8).
3. Replace the lter (7) and proceed in the reverse order to
reassemble the head.
To dispose of the lter put it in a sealed plastic bag, close it
hermetically and dispose of it in accordance with the laws in
force.
Tightness inspection
Hoses check
Make sure the connecting hoses (Fig. 10) are in a good
condition and correctly xed.
If the hoses are damaged, broken or badly connected to the
unions, they must be replaced.
When sticky materials are treated, check for possible clogging
along the hose, in the inlet and on the bafe plate inside the
ltering chamber.
Scrape inlet (2, Fig. 10) from the outside and remove the
deposited waste as indicated in the gure.
Filtering chamber tightness check
If gasket (1, Fig. 11) between container (4) and lter chamber
(3) fails to guarantee a good seal:
Loosen the four screws (2) that lock the ltering chamber
(3) against the vacuum cleaner structure.
Allow the ltering chamber (3) to lower down and tighten
the screws (2) once it has reached the tightness position.
If an optimal seal cannot be obtained and the gasket is torn or
cracked, etc. it must be replaced.
Disposing of the vacuum cleaner
Figure 12
Dispose of the vacuum cleaner in compliance with the laws in
force.
Proper disposal (electric and electronic waste).
(Applicable in the European Union and in countries
providing a separate collection system)
The above symbol (Fig. 12), which is present on the product
or in its documentation, indicates that the product cannot be
disposed of together with other domestic waste at the end of
its life cycle.
To prevent damage to the environment or health caused by
improper waste disposal, please separate this product from
other waste and recycle it responsibly in order to support the
sustainable reutilisation of material resources.
This product can not be disposed of together with other
commercial waste.
24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Nilfisk-ALTO ATTIX 115-01 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Nilfisk-ALTO ATTIX 115-01

Nilfisk-ALTO ATTIX 115-01 Bedienungsanleitung - Holländisch - 56 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info