Bedienungsanleitung Nilfisk-ALTO NEPTUNE 4 FA (Seite 13 von 22) (Englisch)

608957

Zoom out

Zoom in

Vorherige Seite

1/22

Nächste Seite

Options / model variants

Original instructions

NEPTUNE 4 FA

5.1.1 Soaking

Encrusted or thick layers of dirt can be loosened or softened up by a

period of soaking. This is for example an ideal method within agricul-

ture – for example, within pig sties. The ideal soaking method can be

achieved via use of foam or simple alkaline detergent. Let the product

lie on the dirty surfaces for around 30 minutes before pressure wash-

ing. The result will be a much quicker high pressure cleaning process.

5.1.2 Detergent and Foam

Foam or detergent should be applied onto dry surfaces so that the

chemical product is in direct contact with the dirt. Detergents are

applied from bottom to top, for example on a car bodywork, in order

to avoid “super clean” areas, where the detergent collects in higher

concentration and streams downwards. Let the detergent work for

several minutes before rinsing before rinsing but never let it dry on

the surface being cleaned.

5.1.3 Temperature

Detergents are more effective at higher temperatures. Greases, oils

and fats can be broken down more easily at higher temperatures

also. Proteins can be cleaned at temperatures of around 60°C. Oils,

trafﬁ c ﬁ lm around 70°C, and grease can be cleaned at 80°C - 90° C.

5.1.4 Mechanical Effect

In order to break down tough layers of dirt, additional mechanical

effect may be required. Special lances and rotary or wash brushes

offer this supplementary effect that cuts through dirt.

5.1.5 High Water Flow or

High Pressure

High pressure is not always the best solution and high pressure

may damage surfaces. The cleaning effect also depends upon water

ﬂ ow. Pressure levels of around 100 bar may be sufﬁ cient for vehicle

cleaning (in association with hot water). Higher ﬂ ow levels give the

possibility to rinse and ﬂ ush away large amounts of dirt easily.

5.2 Some typical cleaning tasks

5.2.1 Agriculture

Task Accessories Method

Stables

Pig Pens, Sties

Cleaning of walls,

floors and equip-

ment

Disinfectant

Chemical Foam Injec-

tors

Foam lance

Powerspeed lance

Floor Cleaner

Detergents

Universal

Alkafoam

Disinfectant

DES 3000

1. Soaking – apply foam to all surfaces (bottom to top)

and wait for approx. 30 minutes.

2. Remove the dirt from surfaces with the high pressure

lance or chosen accessory. Again, clean from bottom

to top on vertical surfaces.

3. To ﬂ ush away large quantities of dirt, change to low

pressure mode and use the higher ﬂ ow to push away

the dirt.

4. Use recommended disinfectant products and methods

to ensure hygiene. Apply DES 3000 disinfectant once

the surfaces are perfectly clean.

Machinery

Tractors

ploughs etc.

Detergent injection

Powerspeed lances

Curved lances and un-

derchassis washers

Brushes

1. Apply detergent to vehicle or equipment surfaces in

order to soften up dirt and grime. Apply from bottom

to top.

2. Proceed with cleaning using the high pressure lance.

Clean again from bottom to top. Use accessories to

clean in difﬁ cult to reach places.

3. Clean fragile areas such as motors, rubber at lower

pressure levels to avoid damage.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nilfisk-ALTO NEPTUNE 4 FA Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Nilfisk-ALTO NEPTUNE 4 FA

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info