Bedienungsanleitung Nilfisk-ALTO Poseidon 8 (Seite 5 von 16) (Englisch)

493191

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

POSEIDON 8

Wear appropriate protective

clothing and eye protectors.

Do not direct the jet towards

yourself or towards other per-

sons in order to clean clothes

or footwear.

During operation of the cleaner,

recoil forces are produced at the

spraying device and, when the

spray lance is held at an angle,

a torque is also created. The

spraying device must therefore

be held firmly in both hands.

Do not use the cleaner when

other people without protec-

tive clothing are in the working

area.

Check that cleaning will not

result in dangerous substanc-

es (e.g. asbestos, oil) being

washed off the object to be

cleaned and harming the envi-

ronment.

Do not clean delicate parts

made of rubber, fabric, etc. with

the 0° jet. Keep some distance

between high pressure nozzle

and surface in order to prevent

the surface from damage.

Do not use the high-pressure

hose for lifting loads.

NOTE!

The maximum permissible

working pressure and temper-

ature are printed on the high-

pressure hose.

Do not continue to use the

cleaner if the mains power lead

or high-pressure hose is dam-

aged.

Ensure adequate air circulation.

Do not cover the cleaner or op-

erate it in inadequately venti-

lated rooms!

Store the cleaner where

it will not be exposed to

frost!

Never operate the cleaner with-

out water. Even brief shortages

of water result in severe dam-

age to the pump seals.

Water connection

This high pressure

washer is only al-

lowed to be connect-

ed with the drinking

water mains, when

an appropriate backflow pre-

venter has been installed, Type

BA according to EN 1717. The

backflow preventer can be or-

dered under number 10641117

7,106411178,106411179,1064

11184. The length of the hose

between the backflow preventer

and the high pressure washer

must be at least 12 metres (min

diameter 3/4 inch) to absorb

possible pressure peaks. Op-

eration by suction (for example

from a rainwater vessel) is car-

ried out without backflow pre-

venter. Recommended suction

set: 61256. As soon as water

has flown through the BA valve,

this water is not considered to

be drinking water any more

Operation

CAUTION!

Unsuitable extension leads can

represent a source of danger.

Always unwind cord from the

reels completely to prevent the

power cord overheating.

Plugs and connectors of mains

power leads must be at least

splash water-proof.

When using an extension cord,

check the minimum cross-sec-

tions of the cable:

Cable length

Cross section

<16 A <25 A

up to 20 m

ø1.5mm² ø2.5mm²

20 to 50 m

ø2.5mm² ø4.0mm²

Do not damage the mains pow-

er lead (e.g. by driving over it,

pulling or crushing it).

Disconnect the power cord by

pulling the plug only (do not pull

or tug the power cord).

Electrical equipment

CAUTION!

Never spray electrical equip-

ment with water: danger for per-

sons, risk of short-circuiting.

The cleaner may only be con-

nected to a correctly installed

plug socket.

Switching on the cleaner may

cause voltage fluctuations.

Voltage fluctuations should

not occur if the impedance at

the transfer point is less than

0.15 Ω. If in doubt ask your local

electricity supplier.

Maintenance and repair

CAUTION!

Always remove the plug from the

mains plug socket before clean-

ing or carrying out maintenance

work on the cleaner.

Carry out only the maintenance

operations described in the op-

erating instructions. Use only

original Nilfisk-Alto spare parts.

Do not make any technical mod-

ifications to the high-pressure

cleaner.

Ensure that the machine is reg-

ularly serviced by Authorised

Nilfisk-Alto dealers in accord-

ance with the maintenace plan.

Failure to do so will invalidate

the warranty.

CAUTION!

High-pressure hoses, fittings

and couplings are important for

the safety of the cleaner. Use

only high-pressure parts ap-

proved by the manufacturer!

The mains power lead must not

differ from the version specified

by the manufacturer and may

only be changed by an electri-

cian.

Please contact the Nilfisk-Alto

service department or an au-

thorised specialist work-shop for

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nilfisk-ALTO Poseidon 8 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Nilfisk-ALTO Poseidon 8

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info