Bedienungsanleitung Nilfisk-ALTO Poseidon 8 (Seite 10 von 16) (Englisch)

493191

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

POSEIDON 8

5.1.4 Mechanical Effect

In order to break down tough layers of dirt, additional mechanical

effect may be required. Special lances and rotary or wash brushes

offer this supplementary effect that cuts through dirt.

5.1.5 High Water Flow or

High Pressure

High pressure is not always the best solution and high pressure may

damage surfaces. The cleaning effect also depends upon water

ﬂ ow. Pressure levels of around 100 bar may be sufﬁ cient for vehicle

cleaning (in association with hot water). Higher ﬂ ow levels give the

possibility to rinse and ﬂ ush away large amounts of dirt easily.

5.2 Some typical cleaning tasks

5.2.1 Agriculture

Task Accessories Method

Stables

Pig Pens, Sties

Cleaning of

walls, floors and

equipment

Disinfectant

Chemical Foam

Injectors

Foam lance

Powerspeed lance

Floor Cleaner

Detergents

Universal

Alkafoam

Disinfectant

DES 3000

1. Soaking – apply foam to all surfaces (bottom to top)

and wait for approx. 30 minutes.

2. Remove the dirt from surfaces with the high

pressure lance or chosen accessory. Again, clean

from bottom to top on vertical surfaces.

3. To flush away large quantities of dirt, change to low

pressure mode and use the higher flow to push

away the dirt.

4. Use recommended disinfectant products and

methods to ensure hygiene. Apply DES 3000

disinfectant once the surfaces are perfectly clean.

Machinery

Tractors

ploughs etc.

Detergent injection

Powerspeed lances

Curved lances and

underchassis washers

Brushes

1. Apply detergent to vehicle or equipment surfaces in

order to soften up dirt and grime. Apply from bottom

to top.

2. Proceed with cleaning using the high pressure

lance. Clean again from bottom to top. Use

accessories to clean in difficult to reach places.

3. Clean fragile areas such as motors, rubber at lower

pressure levels to avoid damage.

5.2.2 Vehicle

Task Accessories Method

Vehicle bodywork Standard lance

Detergent injection

Curved lances and

underchassis washers

brushes

Detergents

Aktive Shampoo

Aktive Foam

Sapphire

Super Plus

Aktive Wax

Allosil

RimTop

1. Apply detergent to vehicle or equipment surfaces

in order to soften up dirt and grime. Apply from

bottom to top. In cases of particularly dirty vehicles,

pre-spray with a product such as Allosil in order

to remove traces of insects etc, then rinse at low

pressure and apply normal car cleaning detergent.

Let detergents settle for 5 minutes before cleaning

off. Metallic surfaces can be cleaned using RimTop.

2. Proceed with cleaning using the high pressure

lance. Clean again from bottom to top. Use

accessories to clean in difficult to reach places.

Use brushes in order to add a mechanical cleaning

effect. Short lances can help for cleaning of motors

and wheel arches. Curved lances or undercarriage

washers can be valuable for the cleaning of car

underchassis and wheel arches.

3. Clean fragile areas such as motors, rubber at lower

pressure levels to avoid damage.

4. Apply a liquid wax using the pressure washer in

order to protect the bodywork from pollution.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nilfisk-ALTO Poseidon 8 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Nilfisk-ALTO Poseidon 8

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info