Bedienungsanleitung Nilfisk-ALTO SCRUBTEC 653B (Seite 75 von 124) (Deutsch, Englisch, Holländisch, Französisch)

609451

Zoom out

Zoom in

Vorherige Seite

1/124

Nächste Seite

9097058000(2)2009-10 A SCRUBTEC 653B – 653BL – 651BCL – 661BL 13

USER MANUAL

ENGLISH

USE

WARNING!

On some points of the machine there are some adhesive plates indicating:

– DANGER

– WARNING

– CAUTION

– CONSULTATION

While reading this Manual, the operator must pay particular attention to the symbols shown on the plates.

Do not cover these plates for any reason and immediately replace them if damaged.

BATTERY CHECK/SETTING ON A NEW MACHINE

WARNING!

The electric components of the machine can be seriously damaged if the batteries are either improperly installed

or connected. The batteries must be installed by qualied personnel only. Set the function electronic board and

the battery charger (optional) according to the type of batteries used (WET or GEL).

Check the batteries for damage before installation.

Disconnect the battery connector and the battery charger plug.

Handle the batteries with great care.

Install the battery terminal protection caps supplied with the machine.

The machine requires two 12 V batteries, connected according to the diagram (57).

The machine can be supplied in one of the following modes:

A) Batteries (WET or GEL) already installed and ready to be used

1. Check that the batteries are connected to the machine with the connector (12).

2. Insert the ignition key (80) and turn it to “I”.

If the green warning light (81a) turns on, the batteries are ready to be used.

If the yellow or red warning light (81b or 81c) turns on, the batteries must be charged (see the procedure in Maintenance

chapter).

B) Batteries (WET) installed on the machine, but without electrolyte

1. Open the cover (22) and check that the recovery tank (21) is empty, otherwise empty it with the drain hose (16).

2. Carefully lift the tank (40).

3. Remove the caps (53) of the batteries (52).

WARNING!

Pay attention when using sulphuric acid, as it is corrosive. If it comes in contact with skin or eyes, rinse

thoroughly with water and consult a physician.

Batteries have to be lled in a well-ventilated area. Wear protective gloves.

4. Fill up the battery cells with sulphuric acid for batteries (density 1.27 to 1.29 kg at 25°C) in accordance with the instructions

shown in the Battery Manual. The correct quantity of sulphuric acid is shown in the Battery Manual.

5. To avoid damaging the oor, dry with a cloth both acid and water on the top of the batteries after charging.

6. Let the batteries rest and ll in with sulphuric acid as shown in the Battery Manual.

7. Charge the batteries (see the procedure in Maintenance chapter).

C) Without batteries

1. Buy appropriate batteries (see Technical Data paragraph).

2. For battery choice and installation, apply to qualied battery Retailers.

3. Set the machine and the battery charger (if equipped) according to the type of batteries installed (WET or GEL) as shown

in the following paragraph.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nilfisk-ALTO SCRUBTEC 653B Seite 75

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info