Bedienungsanleitung Nilfisk IVB2000 (Seite 43 von 72) (Deutsch, Englisch, Holländisch, Französisch)

20231

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

USER MANUAL

32401131(1)2005-03 A 7

6 Controls (Fig. 3)

1. Filter clogging indicator. When the yellow light turns

on, the filter is clogged or the suction flow is

obstructed downstream of the filter. Remove the

accessories and try to check.

If the yellow light stays on, the filter must be cleaned

and, if necessary, replaced. For further information,

see paragraph 8.2.

2. Power on indicator

3. If the white light turns on, the vacuum cleaner is

operating.

Motors ON/OFF switches, green coloured (there

can be 2 or 3 switches, according to the type of

vacuum cleaner).

7 Starting and stopping (Fig. 3

and 4)

7.1 Precautions

7.2 Starting

Make sure that the vacuum cleaner has been properly

connected to the electrical mains. In particular, ensure

that the electrical mains voltage and frequency values

match the data on the vacuum cleaner plate (see

Fig.1).

Install the desired accessories to the suction inlet.

Bring the vacuum cleaner where it has to be used. Lock

the front wheels by pressing the locking levers

downwards.

Insert the power cord plug into the wall socket.

In order to start the motors (2 or 3 motors), press the

green switches, one at a time.

The lighting of the green light indicates that the motor is

running.

In order to obtain the maximum suction power, all the

motors (2 or 3) must be turned on, and they must

operate simultaneously.

The motors must always be turned ON and OFF one at

a time.

When a lower suction power is required, it is possible to

use only one motor at a time.

8 How to use the vacuum

cleaner

8.1 Correct use

Before using the vacuum cleaner, connect the hose to

the suction inlet (see paragraph 7.2).

If the suction hoses are very long, try to keep them as

straight as possible.

Do not allow them to become bent or twisted as this will

cause easy wear and clogging.

When the vacuum cleaner is turned on, the suction

power is created to collect the waste material through

the suction inlet.

The waste material passes through the hose and the

accessories until it reaches the suction inlet “4” and

then proceeds to the dust container “6” where a baffle

“5” in the filtering unit subjects it to a centrifugal action

causing the heavier solids to drop to the bottom of the

dust container “6”.

The main filter “3” retains the lighter particles in the

suction flow which proceeds to the HEPA filter, if

installed.

WARNING!

Unauthorized personnel are forbidden to

use the vacuum cleaner.

The operator must make sure that the all

protections and safety devices are

installed and efficient.

WARNING!

If the vacuum cleaner is used for

collecting fluids or wet materials, and

leaks occur, the vacuum cleaner must be

immediately turned off, cleaned and dried,

and all filters must be replaced.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nilfisk IVB2000 Seite 43

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Nilfisk IVB2000

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info