Bedienungsanleitung Nilfisk IVB2000 (Seite 50 von 72) (Deutsch, Englisch, Holländisch, Französisch)

20231

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

USER MANUAL

14 32401131(1)2005-03 A

14.5 Replacing the main filter (Fig. 8)

Perform the main filter replacement outdoors, if

possible.

The old filter must be disposed of in a special plastic

bag.

Loosen the bracket that fixes the filtering unit to the

vacuum cleaner.

Remove the vacuum cleaner motor head. Lift the filter

to remove it from the filtering unit. Loosen the strap that

retains the filter onto the ring.

Turn the filter upside down until the retaining strap “2”

is exposed.

Place the filter in a plastic bag “3”; then, cut the

retaining strap to disengage the cage from the filter.

Seal the plastic bag containing the filter. Do not throw

away the filter if it is soiled with toxic dust or harmful

materials. The filter must be handed over to the

authorities in possession of the necessary permission

to dispose of such waste. When replacing the main filter

or the absolute filter, wear a P3 mask.

Buy a new filter having the same characteristics of the

filter you intend to replace, and proceed as follows:

(Fig. 8). Disassemble the old filter retainer and the

retaining ring, and mount them on to the new filter.

Install the filter cage “4” and fix it with the retaining

straps “2” to the lower part of the filter.

Insert the filter cage shaft into the filter shaker system

and tighten the screws.

Attach the top cover to the filtering unit.

Lift the filtering unit to reinstall it inside the vacuum

cleaner body.

Tighten the strap that fixes the filtering unit to the

vacuum cleaner.

To replace the filter it is necessary to use a screwdriver

and pliers for wires.

14.5.1 Replacing the absolute filter (HEPA)

When installed, the absolute filter should be replaced in

the following way:

Loosen the strap retaining the motor head to the

filtering unit. Remove the motor head to reach the

HEPA filter.

Remove the absolute filter and replace it with a new

one.

Reinstall the motor head and close the strap.

The removed filter must be wrapped in a plastic bag

and properly disposed of.

When replacing the main filter or the absolute filter take

special care and wear a P3 mask.

WARNING!

When the vacuum cleaner has been used

to collect materials that are dangerous for

the operator’s health, the personnel in

charge for the maintenance must wear

appropriate protective clothing.

WARNING!

Filter replacement is a serious matter. The

filter must be replaced with one of

identical characteristics, category and

filtering surface. Failure to comply with

these instructions could jeopardize the

correct operation of the vacuum cleaner.

WARNING!

When the vacuum cleaner has been used

to collect materials that are dangerous for

the operator’s health, the personnel in

charge for the maintenance must wear

appropriate protective clothing.

NOTE

The absolute filter is toxic waste and must be

treated as such. The filter must be handed

over to one of the authorities in possession of

the necessary permission to dispose of such

waste.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nilfisk IVB2000 Seite 50

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Nilfisk IVB2000

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info