Bedienungsanleitung Nilfisk P 130.1 (Seite 5 von 12) (Englisch)

529018

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

Preparation EN

• Never try to clean clothes or foot wear on your self

or other per sons.

• Do not let children or people who have not read

the instruction manual ope rate the ma chine.

• Never use the machine in an en vi ron ment where

there could be a danger of ex plo sion. If any doubt

arises, please contact the local authorities.

• It is not allowed to clean asbestos- containing

sur fac es with high pressure.

Safety devices

Locking device on spray gun

The spray gun features a locking device (6b). When

the pawl is activated, the spray gun can not be ope-

rated.

Thermal sensor:

A thermal sensor protects the motor against over-

loading. The machine will restart after a few minutes

when the thermal sensor has cooled.

Pressure safety device

An integrated hydraulic safety valve protects the

system from excessive pressure

Operating Instructions EN

High pressure

Low pressure

2.0 Operating Instructions

2.1 Operating facilities

• Start-/stop rotary switch (2).

• Spray gun (6) with trigger (6a) and locking device

(6b).

• Dosing regulator for detergents (12).

• Regulation of pressure / water volume (14). (not

available on model B)

2.2 Connection

1. PRO 130/150/160: Attach the high pressure hose

(5) to the connection for high pressure hose (3).

Only use one extension hose of max. 7 m.

PRO 130/150/160 X-TRA: Unwind the high pres-

sure hose completely.

2. Attach the nipple of the high pressure hose to the

spray gun quick coupling.

3. Mount the nozzle or any other equipment you

want to use.

4. Connect the machine to the water and power

supplies.

2.3 Start

1. Check that the machine is in vertical po si tion.

2. Activate the trigger of the spray gun (6a) and let

the water run out until any air has escaped from

the inlet hose.

3. Turn the start/stop switch (2) to pos. I.

2.4 Operation

1. Always hold the spray lance

ﬁ rmly with both hands! The spray

lance is affected by a lon gi tu di nal

thrust of up to 16.4 N when the high

pressure washer is ope rated.

2. Point the nozzle at the ground!

3. Activate the trigger of the spray gun (6a).

4. Always adjust the distance and thus the pres -

sure of the nozzle to the sur face which is to be

cleaned. NOTE: The pressure can be reg u lat ed

on the TORNADO

PR nozzle or the button for

regulation of pressure / water volume (14).

NOTE: Do not cover the machine during operation. If

the machine is left or not used for 5 minutes, it must

be switched off on the start/stop switch (2) pos. O.

Operation with detergents

Application of detergents is NOT possible if an

extension hose is applied.

1. Fill the container with a detergent.

2. Mount the TORNADO

PR nozzle and adjust it to

low pressure (see section 2.4.4).

3. Adjust the dosing regulator (12) to the re quired

vol ume of detergent (0-5%).

4. Apply the detergent from below and up wards.

5. Let the detergent act for the time stated on the

packing of the detergent and ﬂ ush with pure water.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nilfisk P 130.1 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Nilfisk P 130.1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info