787650
27
Zoom out
Zoom in
Vorherige Seite
1/31
Nächste Seite
USER MANUAL
ENGLISH
24
TANK AND DEBRIS COLLECTION BOX CLEANING, AND
COVER GASKET CHECK
1. Drive the machine on a level floor.
2. Ensure the machine is off and the ignition key (40) has been
removed.
3. Turn the recovery tank lid (A, Figure 25) 90 degree position
where it can be took off from the tank, and then take down the
Debris collection box (D, E Figure 25) from the tank.
4. Clean the recovery tank lid (A), recovery tank (B), clean water
tank (C), Debris collection box (D, E Figure 25),Empty the
recovery tank with the drain hose (G, Figure 25).
5. Inspect the integrity of the tank sealing strip.
NOTE
Tank sealing strip (G) makes to produce the
vacuum inside the tank when suction motor works.
The tank must be sealed can effectively absorb the
water from the ground to recovery tank.
6. Check whether the contact surface of sealing strip (G) is
integrity and sealing is sufficient. If necessary, take the sealing
strip of the tank out of the groove (H) and replace it. Assembly
the new sealing strip as shown in Figure 25, the joint should be
back in the middle area.
7. Close the recovery tank lid (A Figure 25).
DETERGENT TANK CLEANING
(For machines with Chemical Mixing System)
Clean the detergent tank (E, Figure 26) as shown below:
1. Drive the machine on a level floor.
2. Turn the ignition key (A) to "0".
3. Open the cover (B) and check that the recovery water tank (C)
is empty; if necessary empty it with the drain hose (H, Figure
26). Close the cover (B).
4. Carefully lift the tank (C).
5. Unscrew the plug (E) and disconnect the hose (F) from the tank
(G).
6. Remove the tank.
7. Wash the tank in the appointed disposal area.
8. Install the tank (G) and connect the hose (F).
9. After draining the detergent tank, drain the Chemical Mixing
System too by running the system with clean water only.
H
B
A
C
F
E
G
D
F
C
A
D
E
B
G
H
Figure 25
Figure 26
27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Nilfisk SC3500 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info