Bedienungsanleitung Nilfisk steamtec 520 (Seite 3 von 81) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

382334

Zoom out

Zoom in

Vorherige Seite

1/81

Nächste Seite

STEAMTEC 520

english

For your own safety

The use of the steam cleaner is

subject to valid national regula-

tions. Besides the operating

instructions and the binding

accident prevention regula-

tions valid in the country of use,

observe recognized regulations

for safety and proper use.

Do not use any unsafe work

techniques.

Before start-up

Before starting up the cleaner,

check that it is in proper condi-

tion.

Do not switch the cleaner on if

there is no water in the boiler.

Do not start the cleaner near

explosive and/or easily flamma-

ble substances.

Use only tap water or distilled

water to fill the boiler. Distilled

water extends the service life of

the cleaner. Cleaning agents,

scents, solvents and other

chemical substances may dam-

age the cleaner and may be a

risk to health.

Regularly check whether the

steam hose and power cord

are damaged or show signs of

age. Only use the cleaner if the

steam hose and power cord are

intact.

Check the rated voltage of

the steam cleaner before con-

necting it to the mains supply

system. Ensure that the voltage

shown on the rating plate cor-

responds to the voltage of the

local mains power supply.

Never touch the plug and elec-

trical cables with wet hands.

It is recommended that the

steam cleaner should be con-

nected via a residual current

circuit breaker. This stops the

supply of electricity if the leak-

age current to earth exceeds 30

mA for 30 ms or it has an earth

tester circuit.

During use

Never leave the cleaner unsu-

pervised when it is connected.

Never turn the cleaner over or

tilt it while it is in operation.

Never use the cleaner when

other people are nearby.

Place the cleaner as far away

as possible from the object to

be cleaned.

Filling aperture must not be

opened during use.

Do not leave the cleaner near to

sources of heat (fire, radiators,

heating fans or other equipment

that radiates heat) and never

cover the cleaner.

The steam jet can be danger-

ous if it is misused. Never direct

the jet on to persons, animals,

electrically powered equipment

or the cleaner itself.

Remove condensed water from

the nozzle before starting up

the cleaner and after every

work break. To clean the nozzle,

direct the steam jet into a tank

or sink and actuate the steam

lever on the steam gun. After

cleaning the nozzle you can

begin work again as normal.

CAUTION:

Materials containing asbestos

and other hazardous substanc-

es should not be cleaned.

Do not use the steam jet to

clean switches, sockets, con-

trollers, etc. and other electrical

parts on electrical cleaners.

Make sure that the child-proof

lock is actuated on the handle

during work breaks.

To prevent the cleaner from

being used inadvertently dur-

ing work breaks, switch off the

cleaner and pull out the mains

plug.

Before using

the steam

cleaner, al-

ways read the

operating in-

structions and keep

them readily available.

The appliance is not to be used

by children or persons with

reduced physical, sensory or

mental capabilities, or lack of

experience and knowledge, un-

less they have been adequately

supervised by a responsible

person to ensure that they can

use the appliance safely (IEC/

EN 60335-1) (deviations for

Australia and New Zealand).

Young children should be su-

pervised to ensure that they

do not play with the appliance

(IEC/EN 60335-1) (deviations

for Australia and New Zealand).

CAUTION:

Danger of scalding! The steam

produced by the appliance can

reach very high temperatures.

Metal parts, water and hot

steam can cause severe burns.

Avoid contact with hot cleaner

surfaces, emerging water and

steam.

The pressure tank is under

pressure during operation. For

this reason, never open the

safety catch during operation.

Be careful particularly during

the following work as there may

still be hot steam in the cleaner:

– Opening the safety catch.

The safety catch has a pres-

sure relief hole. Open the

safety catch by one or two

turns. Wait until no steam

emerges. Then completely

open the safety catch.

– Refilling the boiler

– Emptying the boiler

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nilfisk steamtec 520 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info