18
➔ Wait until the filter symbol
(Symbol 20) lights up and press
the Selection button (fig. 1/E
and 6).
➔ Symbols 14 and 9 start to
flash.
➔ Press the Selection button (fig.
1/E and 6) until only Symbol 14
(‘filter OFF’) flashes.
➔ Press and hold the Service but-
ton (fig. 1/I) for about 4 seconds
to confirm.
➔ The programming operation is
now complete and the system
returns to stand-by mode.
Note: Do not forget to set the
water hardness (see point 4.2).
4.2 Water hardness
Depending on the water hardness
in your region, or if you have not
inserted a filter (see chapter 4.1),
the machine sooner or later requi-
res descaling. So that the system
can indicate correctly when desca-
ling is necessary, you must enter
the correct water hardness set-
tings before the first use.
The default setting is level 3, indi-
cated by Symbols 14 and 10.
First, test your water with the test
strips provided:
➔ Dip the strip into the water and
then shake it lightly off.
➔ After about a minute you can
read the result by counting the red
dots on the test strip.
➔ The settings corresponding to
the different levels of hardness are
as follows:
Test strip / hardness level = Symbol
for setting:
1 red dot / 1–7° = 14
2 red dots / 8–14° = 14 and 9
3 red dots / 15–21° = 14 and 10
4 red dots / > 21° = 14 and 11
Note: If none of the dots turn red
on the test strip, please set
level 1, Symbol 14.
➔ Switch your machine off (stand-
by mode) by pressing the On / Off
button (fig. 1/F).
➔ Press and hold the Service but-
ton (fig. 1/I) for about 4 seconds
to enter programming mode.
➔ Symbols 20, 18, 8 and 16 light
up and rotate sequentially in the
display. (The symbol for water
hardness, Symbol 18, does not
appear if the filter function is set
to ‘ON’, see chapter 4.1).
... 4. Programming functions
