25
Manual descaling
If required, the descaling program
can also be started even if no
indication has been displayed by
the machine that this is necessary:
➔ Press the program key ‘P’ to
enter programming mode.
➔ Press the > key until “PROGRAM
DESCAL.” appears.
➔ Press the ‘ok’ key. The display
reads “MAN. DE-SCALING”.
➔ Press the ‘ok’ key. “EMPTY
TRAYS” appears in the display.
➔ Continue as described above,
from Point 5.4, step ‘Empty the
drip tray …
Tip: If you start the manual desca-
ling program by accident, you can
cancel the operation at the start
by pressing and holding the On /
Off button (fig. 1/F) for about 4
seconds. The machine may ask
you to change the water.
5.5 General cleaning
Caution: Never submerge the
machine in water. Do not use
abrasive materials to clean the
machine.
➔ Wash the case inside and out
with a soft, damp cloth only.
➔ Empty the drip tray (fig. 1/W)
and the used coffee tray (fig. 1/U)
only when instructed to do so by
the display. From time to time
use soapy water to clean.
Important: When cleaning the drip
tray (fig. 1/W), make sure that the
two contacts on the back of the
tray are always clean and dry.
➔ The water reservoir (fig. 1/B
and 2) should be rinsed out and
refilled with fresh, cold water daily.
➔ Clean the hot water and steam
jet (fig. 1/T) with a damp cloth or
flush it out with fresh, cold water
until it is completely clean (see
also cleaning note under point 3.8).
Cleaning the brewing unit
If required, the brewing unit can
be removed and cleaned under
running water. Please use only
water to do this, not cleaning
agents.
➔ The machine must be in stand-
by mode for this operation!
➔ Remove the right cover by
unscrewing both screws (e.g. with
a 5-cent coin).
... 5. Maintenance and Care
