4.2 Water hardness
According to the water hardness in
your region, or if you have not
inserted a filter (see chapter 4.1),
sooner or later the machine needs
descaling. So that the system can
indicate accurately when desca-
ling is necessary, you must enter
the correct water hardness set-
tings before first use.
The default setting is level 3.
First, test your water with the test
strips provided:
➔ Dip the strip into the water and
then shake it lightly off.
➔ After about a minute you can
read the result by counting the red
dots on the test strip.
➔ The settings corresponding to
the different levels of hardness are
as follows:
Note: If none of the dots turn red
on the test strip, please set to
level 1.
➔ Switch your machine ON.
➔ Press the steam warm-up button
(fig. 1/O) for about 5 seconds.
➔ The water hardness is indicated
by the number of buttons lit up as
detailed below.
➔ Press the steam warm-up button
repeatedly until the buttons which
indicate your level of water hard-
ness light up.
➔ Press the coffee strength button
to confirm.
➔ To confirm your settings, the
buttons which indicate the level
selected flash twice consecutively.
➔ The programming operation is
then complete and the system is
restored to coffee-brewing mode.
... 4. Programming functions
Test strip Hardness level Symbol for setting
1 red dot 1–7° Coffee strength is lit up Level 1
2 red dots 8–14° Coffee strength + 1-cup button are lit up Level 2
3 red dots 15–21° Coffee strength + 1-cup button
+ 2-cup button are lit up Level 3
4 red dots >21° Coffee strength + 1-cup button
+ 2-cup button
+ S/steam button are lit up Level 4
49
