Bedienungsanleitung Nokia 150S (Seite 34 von 38) (Englisch)

29440

Zoom out

Zoom in

Vorherige Seite

1/38

Nächste Seite

GB 34

Troubleshooting

Problem

The LED on the front panel does

not light up/is not lit.

The left-hand LED is red

No sound or picture.

No sound or picture on the horizon-

tal modulated transponder.

Bad picture/blocking error.

There is no Welcome menu on the

screen after you have switched the

Mediamaster on for the first time.

You made a video recording from a

digital satellite channel and the

whole programme, or parts of it,

were not recorded.

The remote control is not working.

You have forgotten your secret ac-

cess code.

In the software update state, both

LEDs simultaneously blink red a

few times before system start-up.

In the software download state

both LEDs blink red alternatively.

After the software update, or when

you start-up your Mediamaster,

both LEDs blink red simultane-

ously.

Possible causes

The mains cable is not connected.

The Mediamaster is in standby

mode.

The satellite dish is not pointing

at the satellite.

There is no signal or only a weak

signal.

The LNB is faulty.

The satellite dish is not pointing

at the satellite.

The signal is too strong.

The satellite dish is too small.

LNB noise factor is too high.

The LNB is faulty.

The system is connected by SCART

cables and the TV is not in AV/EXT

mode.

The Mediamaster was not left on

the appropriate channel.

The system is connected by SCART

cables and the VCR is not in AV/EXT

mode.

The batteries are exhausted.

The remote control is incorrectly

aimed.

The Mediamaster is in standby

mode.

There is a software download error.

There is no signal or only a weak

signal.

System failure.

What to do

Check that the mains cable is plugged

into the power socket.

Press the standby button to take the

Mediamaster out of standby mode.

Adjust the dish. Check the signal level

indicator in one of the channel search

submenus.

Check the cable connections, LNB,

and other equipment that is connected

to the LNB and the receiver, or adjust

the dish.

Replace the LNB.

If you have a long cable, increase the

LNB voltage by 0.5 V using the An-

tenna/Satellite Configuration menu.

Adjust the dish.

Connect a signal attenuator to the LNB

input.

Change to a larger dish.

Change to an LNB with a lower noise

factor.

Change the LNB.

Switch the TV to the appropriate AV

input.

If you make a recording froma digital

satellite TV channel, your Mediamaster

must be left on the channel from

which you want to record.

Switch the VCR to appropriate the AV

input.

Change both batteries.

Aim the remote control at the box.

Check that nothing is blocking the

front panel.

Check whether LED indicator 2 on the

front panel is flashing when you press

a button. If not, replace both batteries.

Contact your dealer or Service Pro-

vider. They will help you set it up

again.

Try to update the software.

Check the cable connections, LNB,

and other equipment that is connected

to the LNB and the receiver, or adjust

the dish.

Disconnect the mains cable. When

you reconnect it, the Mediamaster will

try to download new software from

the satellite. Try to update the system

software via serial cable connection.

Contact your dealer.

In case your problem with Mediamaster does not match any of the above mentioned situations and you cannot

solve it accordingly, try the following instructions:

Unplug and then plug in the mains cable.

1) If Mediamaster starts normally and works correctly, this is all you have to do.

2) When reconnected, the green LEDs blink one at a time. Wait! Keep the receiver connected to the mains outlet and the

antenna. Mediamaster is trying to update the system software from a satellite. This may take thirty minutes.

3) If the receiver starts but you cannot enter the Settings/Reinstall through the Navi Bars, activate Reinstall by pressing

all three buttons on the receiver front panel and keeping them down for three seconds. Note that Reinstall will reset ALL

your previous settings and favorite lists. If you have tried all of the above actions without solving the problem, please

contact your dealer or Service Provider.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nokia 150S Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Nokia 150S

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info