Bedienungsanleitung Nokia 9000i (Seite 15 von 126) (Englisch)

297910

Zoom out

Zoom in

Vorherige Seite

1/126

Nächste Seite

Chapter 2 - Getting started 2-5

municator until the left locking pin engages.

(If you try to force the adapter into place up-

side down, you may accidentally break off the

curved guiding pin.)

3 Connect the charger lead to the adapter, as

shown in figure 2-8.

4 Connect the charger to an AC wall outlet. If

the phone interface is switched on, the

CHARGING message appears on the display

and segments of the battery indicator bar on

the right side of the phone interface display

will start scrolling. (Charging information is

also shown on the communicator interface

display, see ”Indicators” on page 2-9.)

5 When the battery is fully charged (the bars stop

scrolling and five bars are displayed), you may

remove the adapter from the communicator:

Hold down the release button on the left side

of the adapter (see figure 2-7), and turn the

adapter away from the communicator.

When the charge is low and only a few minutes

of operation time remain, a warning tone will be

heard, and the message BATTERY LOW will be re-

peated at regular intervals on the display. When

the charge level becomes too low for operation,

the RECHARGE BATTERY message will be dis-

played, accompanied by a warning tone. If you do

not connect the communicator to a charger, the

communicator automatically switches itself off.

Note: If the tones have been switched off (see

chapter 4 "Telephone: Telephone settings

- Ringing settings" on page 4-6), only the

display messages will appear.

Using the battery

Use only batteries approved by the communicator

manufacturer. With approved chargers and acces-

sories, the battery can be charged continuously.

The battery need not be fully discharged before

recharging. When a charger is not in use, discon-

nect it from the power source.

The battery can be charged and discharged hun-

dreds of times, but it will eventually wear out.

When the operation time (talk-time and standby

time) is noticeably shorter than normal, it is time

to buy a new battery.

Temperature extremes will affect the ability of

your battery to charge: it may require cooling or

warming first.

Battery operation time is affected by the follow-

ing: whether both interfaces are on, radio signal

strength, various phone settings, and the length

of the communicator interface’s screen blanker

period (set in System application’s settings, see

chapter 10 "System: System settings" on page

10-1).

It is recommended always to keep a charged bat-

tery in the communicator. Keeping the battery

charged maximises the lifetime of the backup bat-

tery supplying power to the communicator’s real-

time clock. In case the backup battery is drained,

it may be replaced by qualified personnel.

Always close the device cover before removing

the battery. Closing the cover will save all data.

Figure 2-7

Figure 2-8

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nokia 9000i Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Nokia 9000i

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info