Bedienungsanleitung NordicTrack T 14.0 - NETL12710.1 (Seite 19 von 36) (Englisch)

605357

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

4. Change the incline of the treadmill as desired.

To change the incline of the treadmill, press the

ncline increase or decrease button or one of the 1

Step Incline buttons numbered 0 to 12. Each time

ou press one of the buttons, the incline will gradu-

ally change until it reaches the selected incline set-

ting.

5. Select a display mode and monitor your

progress with the display.

The console offers several display modes. The dis-

play mode that you select will determine which

workout information is shown. To select the de-

sired display mode, repeatedly press the Display

button on the screen.

As you walk or run on the treadmill, the display can

show the following workout information:

• The elapsed time.

• The distance that you have walked or run.

• The approximate number of calories you have

burned.

• Your pace in minutes per mile or minutes per

kilometer.

• The speed of the walking belt.

• The incline level of the treadmill.

• Your heart rate (see step 6 on this page). Your

heart rate will be displayed only when you use

the handgrip pulse sensor or the chest pulse

sensor.

As you exercise, the intensity meter willindicate the

approximateintensity level of your exercise.

6. Measure your heart rate if desired.

Note: If you use the handgrip pulse sensor and

the chest pulse sensor at the same time, the

console will not display your heart rate accu-

rately. For information about the chest pulse sen-

sor, see page 14.

Before using

the handgrip

pulse sensor,

emove the

sheets of plas-

ic from the

metal contacts.

In addition,

make sure that

your hands are

clean.

To measure your heart rate, stand on the foot

rails and hold the contacts for approximately

ten seconds—avoid moving your hands. When

your pulse is detected, your heart rate will be

shown. For the most accurate heart rate read-

ing, continue to hold the contacts for about 15

seconds.

7. Turn on the fan if desired.

The fan features high and low speed settings.

Press the Fan button repeatedly to select a fan

speed or to turn off the fan. Note: If the fan is on

when the walking belt is stopped, the fan will turn

off automatically after a few minutes.

8. When you are finished exercising, remove the

key from the console.

Step onto the foot rails, press the Stop button, and

adjust the incline of the treadmill to the lowest

setting. The incline must be at the lowest set-

ting when you fold the treadmill to the storage

position, or you may damage the treadmill.

Next, remove the key from the console and put it in

a secure place.

When you are finished using the treadmill, press

the power switch into the off position and unplug

the power cord. IMPORTANT: If you do not do

this, the treadmillʼs electrical components may

wear prematurely.

ontacts

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

NordicTrack T 14.0 - NETL12710.1 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von NordicTrack T 14.0 - NETL12710.1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info