33
GB
sponge to sweep off laterally the
defrost water so that it can be
collected in a drain at the bottom of
the product and then remove the
water as follows:
Place a tray of sufficient height in front
of the product.
Following the arrow, carefully pull out
the defrost water drain, located in the
central bottom section of the product,
to let the defrost water flow into the
tray.
The defrosting process will be quicker
if you put a pan filled with hot water on
the cooling plates used as shelves.
Once defrosting is completed, dry the
wet surfaces and push back the
defrost water drain.
Connect the product to the mains.
Rotate the thermostat to position <<-
18°C>> and let the product operate in
quick freeze mode for at least 2 hours
before putting back the formerly
removed frozen foods.
Regular cleaning
It is practical to clean the inside of the
freezer and defrost it at a time.
Household cleaner or soap must not
be used.
After breaking the circuit wash the
appliance using lukewarm water and
wipe it.
Clean the door gasket with clean
water.
After cleaning apply voltage to the
appliance.
It is recommended to remove the dust
and dirt collected on the back of the
appliance and the condenser once or
twice a year.
When the refrigerator is not in
use
If you do not use the product for longer
periods, make sure to perform the
following:
Set the thermostat to position << >>.
Disconnect the product from the
mains.
Remove all foods from the product.
Perform defrosting and cleaning
operations as described above.
Leave the doors ajar to avoid the
build-up of unpleasant odors.
Trouble shooting
During operation of the appliance
some smaller but annoying trouble
can often occur, which does not
require calling a technician out. In the
following chart information is given
about them to avoid unnecessary
charges on service.
We draw your attention that operation
of appliance goes with certain sounds
(compressor- and circulating sound).
This is not trouble, but means normal
operation.
We draw it to your attention
again that the appliance
operates discontinuously, so the
stopping of compressor does not
mean being no-current. That is why
you must not touch the electrical parts
of the appliance before removing it
from the mains socket.
