- Thoroughly dry the motor unit with a
clean, dry cloth.
Clean the jug after each use:•
- Clean the outside of the jug with a soft,
damp cloth.
- Clean the inside of the jug under
running water. If necessary, use a soft
brush.
- Thoroughly dry the jug with a clean, dry
cloth.
Description (fig. A)
Your 02.210300 Nova soup maker has been
designed for making soups. The appliance is
suitable for indoor use only. The appliance is
suitable for domestic use only.
Fig. A1
1. Control panel
2. Motor unit
3. Overflow sensor
4. Blade
5. Jug connector
6. Jug
7a. Minimum level indicator
7b. Maximum level indicator
8. Handgrip
9. Motor unit connector
10. Heating plate
Fig. A2
11. Start/stop button
12. Program selection button
13a. Heating/blending indicator ("HEAT+STIR")
13b. Heating indicator ("HEAT")
13c. Blending indicator ("STIR")
Use
Setting the program (fig. A)
Press the program selection button (12) 1x •
to heat and blend the ingredients. The
heating/blending indicator (13a) comes on.
The process takes approximately 25
minutes. (Note: The appliance first heats
the ingredients, but does not directly start
blending the ingredients.)
Press the program selection button (12) 2x •
to heat the ingredients.
The heating indicator (13b) comes on. The
process takes approximately 35 minutes.
Press the program selection button (12) 3x •
to blend the ingredients. The blending
indicator (13c) comes on. The process takes
approximately 60 seconds.
Hints for use (fig. A)
Warning!
- Before assembly or disassembly, switch off
the appliance, remove the mains plug from
the wall socket and wait until the appliance
has cooled down.
- Always make sure that the ingredients are
between the minimum level indicator
("MIN") and the maximum level indicator
("MAX").
- Do not switch on the appliance when the
jug is empty.
- Do not overload the appliance. If the
motor stops, immediately switch off the
appliance, remove the mains plug from the
wall socket and allow the appliance to cool
down.
Prepare the ingredients. Make sure that •
the ingredients fit in the jug.
Place the jug (6) on a stable and flat •
surface.
Put the ingredients into the jug (6).•
Mount the motor unit (2) onto the jug (6).•
Insert the mains plug into the wall socket.•
Set the program. Refer to the section •
"Setting the program". The corresponding
program indicator (13) comes on.
Press the start/stop button (11) to start the •
process.
To interrupt the process, press the start/•
stop button (11) again.
If the process is completed, the appliance •
will beep. The corresponding program
indicator (13) starts flashing.
Press the start/stop button (11) to stop the •
process.
Remove the mains plug from the wall •
socket.
Allow the appliance to cool down •
completely.
