Bedienungsanleitung Novamatic TK 606 Z (Seite 33 von 46) (Deutsch, Englisch)

709017

Zoom out

Zoom in

Vorherige Seite

1/46

Nächste Seite

When the programme

has finished the pilot

lights “Ende” is on.

Start/Pause

Press this button to

start the dryer after

having selected the

programme and the

options. The relevant

light will stop flashing.

If the programme

selector dial is turned

to another position,

when the machine is

running, the buzzer

will sound and the

programme phase

indicator lights will

flash. The drum turns

alternately in both

directions during dry-

ing.

All drying pro-

grammes end with a

10 minute cooling

phase (light Cooling is

on). You may remove

the laundry after this

phase.

If the door of the

appliance or the small

door at the bottom is

opened while the pro-

gramme is running,

this button must be

pressed again after

closing the door in

order to restart the

programme from the

point at which it was

interrupted. This but-

ton must be

depressed also after a

power failure and

after having reinserted

the water reservoir, if

it has been emptied in

the middle of a pro-

gramme after lighting

up of light “Behälter”.

In both cases the light

of the Start/Pause

button flashes to

remind you that the

start button needs to

be pressed again.

Indicator lights

These lights indicate

the following func-

tions:

• “Trocknen” -

drying light

This light indicates

that the appliance

is in the drying

phase.

• “Ende” - end of

programme light

This light is on at

the end of the

cooling phase,

during the anti-

creasing phase

and at the end of

the programme.

• “Behälter” -

water reservoir

full light

This light indicates

that the appliance

is in the drying

phase.

This light comes

on at the end of

the programme to

remind you that

the water reser-

voir must be emp-

tied out. If this

light illuminates

during a pro-

gramme this

means that the

water reservoir is

full. The buzzer

sounds, the pro-

gramme stops,

the light of the

Start/Pause but-

ton flashes. This

light comes on

also when the

water reservoir is

not inserted cor-

rectly.

• “Siebe” - filter

cleaning

This light illumi-

nates at the end

of the programme

to remind you that

the filters must be

cleaned.

• Condenser

cleaning

It comes on every

80 cycles to

remind you that

the condenser

must be cleaned.

Cancelling a

programme

Turn the selector dial

to “Aus” to cancel a

programme which is

running. Now you can

select a new pro-

gramme.

At the end of the

programme

If the laundry is not

removed at the end of

the cycle, the dryer

performs an anti-

creasing phase (dura-

tion: 30 minutes maxi-

mum).

Lights “Ende”, and

“Behälter” remain lit

and the buzzer

sounds for 2 minutes.

Turn the programme

selector dial to “Aus”

to switch the machine

off. Remove the laun-

dry from the drum and

carefully check that

the drum is empty.

If you do not intend to

carry out another

wash, close the water

tap. Leave the door

open to prevent the

formation of mildew

and unpleasant

smells.

Turn the programme

selector dial to “Aus”;

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Novamatic TK 606 Z Seite 33

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info