Bedienungsanleitung Novy 686 Fusion (Seite 16 von 24) (Deutsch, Englisch, Holländisch, Französisch)

583086

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Maintenance

Maintenance of the grease ﬁlter

The hood contains one metal ﬁlter which should

be cleaned twice a month.

Grease ﬁlter indication

After 20 cooking hours, the 4 LEDs will start to

blink during 5 minutes, this indicates that the

grease ﬁlter has to be cleaned. When replacing

the cleaned ﬁlter, you have to reset the hood by

pushing the – button during 5 seconds . If you

don’t reset, the LED lights will continu blinking.We

advise you to clean your ﬁlter twice a month for an

optimal operation.

Access to the ﬁlter

Open the rotating valve (A). Protect the hob. You

can take the grease ﬁlter (B) from the hood by

pulling the handle on the ﬁlter. The ﬁlter will come

down.

Cleaning the ﬁlter:

• in the dishwasher

• manually: in a hot solution of water and a

liquid detergent. Rince and allow to dry com-

pletely

Important! The previous instructions need to

be followed. If not an increased ﬁre hazard may

occur.

Belangrijk! Indien de bovenvermelde instructies

niet worden uitgevoerd, ontstaat er door een

te sterke vervuiling, kans op brandgevaar en

rendementsverlies

Recirculation (option)

If you have chosen for recirculation, please follow

the instructions below.

Cleaning indication:

The red LED will light up after 200 working hours

(time to regenerate the Monoblock recirculation

ﬁlter). The recirculation ﬁlter is to be found behind

the grease ﬁlter.

Remove the Monoblock recirculation ﬁlter:

• Open the bottom plate with both hands and

remove the aluminium grease ﬁlter from the

hood.

• The Monoblock recirculation ﬁlter is found

in its opening in the cooker hood. Remove it

from the cooker hood.

Regenerate the Monoblock recirculation ﬁlter:

• The Monoblock can be regenerated up to 12

times. This is done in the oven.

• Place the ﬁlter in the oven for 1 hour at 120°C.

Provide sufﬁcient fresh air in the room where

the oven has been placed, as smells can be

released. Smells can be released when baking

certain kinds of ﬁsh. The best solution for this

is to immediately regenerate the ﬁlter.

Reset the Monoblock recirculation ﬁlter

The cooker hood (motor) must be running!

Simultaneously press + and – for 5 sec. until the

red indicator lamp ﬂashes 3 times for conﬁrmation.

Place the Monoblock recirculation ﬁlter:

• Open the bottom plate with both hands and

remove the aluminium grease ﬁlter from the

hood.

• Place the Monoblock recirculation ﬁlter is its

opening in the cooker hood.

• Put back the aluminium grease ﬁlter and close

the bottom plate.

Deactivate the programming:

Attention! This is not recommended for a cooker

hood with recirculation.

Simultaneously press + and – for 5 sec. until the

third green LED ﬂashes 3 times.

Maintenance of the hood

Please allow the lights to cool down sufﬁciently

before cleaning the hood. Use a soft, wet

cloth and a mild detergent to clean the hood.

Never use aggressive, abrasive detergents or

sponges. Bleach will damage stainless steel. The

stainless steel surfaces can be treated with Novy

Inoxcleaner (906.060) after cleaning.

EN 16

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Novy 686 Fusion Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info