Bedienungsanleitung Novy 7810 (Seite 16 von 24) (Deutsch, Englisch, Holländisch, Französisch)

571905

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

EN 16

Illumination

To activate the lights press button ④. The lights

will switch on at full power.

Lighting can be activated independently from the

motor.

OPTION: kit for remote control (InTouch)

Optionally, there is a kit for a remote control

available which must also be installed if you se-

lect InTouch. If you have a Novy induction hob

with the InTouch function, you can operate all

of the functions of the extraction hood via the in-

duction hob with the optional kit. This kit must be

mounted during the installation and exclusively by

an authorized installer.

MAINTENANCE

Maintenance of the grease ﬁlter

The hood contains two metal ﬁlters which should

be cleaned twice a month.

Grease ﬁlter indication

After 20 cooking hours, the 4 LEDs will start to

blink during 5 minutes, this indicates that the

grease ﬁlter has to be cleaned. When replacing

the cleaned ﬁlter, you have to reset the hood by

pushing the – button during 5 seconds . If you

don’t reset, the LED lights will continu blinking.

We advise you to clean your ﬁlter twice a month

for an optimal operation.

Access to the ﬁlter

Take hold of the right and left side of the plate (A)

and pull towards you simultaneously.

Remove the ﬁlter (B) by taking hold of its hook

and pulling down.

Cleaning the ﬁlter:

• in the dishwasher

• manually: in a hot solution of water and a

liquid detergent. Rince and allow to dry com-

pletely

Important! The previous instructions need to

be followed. If not an increased ﬁre hazard may

occur.

Recirculation (option)

If you have chosen for recirculation, please follow

the instructions below.

Cleaning indication:

The red LED will light up after 200 working hours

(time to regenerate the used carbon ﬁlter).

Follow the instructions below:

• Open the bottom plate.

• Take the ﬁlter from the hood.

• Take the Monoblock recirculation ﬁlter from

the hood.

ATTENTION: Do not pull the fabric of the

Monoblock ﬁlter!

Regenerate the Monoblock recirculation ﬁlter:

• The Monoblock can be regenerated up to 12

times. This is done in the oven.

• Place the ﬁlter in the oven for 1 hour at 120°C.

Provide sufﬁcient fresh air in the room where

the oven has been placed, as smells can be

released.

• Smells can be released when baking certain

kinds of ﬁsh. The best solution for this is to

immediately regenerate the ﬁlter.

Reprogramming:

Press + and – simultaneously for 5 seconds, the

red LED ﬂashed 3 times for conﬁrmation (if this

programming is not done, the program will be set

automatically after having switched on the device

10 times).

Deactivate the program:

Simultaneously press + and – for 5 sec. until the

third green LED ﬂashes 3 times.

Maintenance of the hood

Please allow the lights to cool down sufﬁciently

before cleaning the hood. Use a soft, wet cloth

and a mild detergent to clean the hood. Never

use aggressive, abrasive detergents or sponges.

Bleach will damage stainless steel. The stainless

steel surfaces can be treated with Novy Inoxclea-

ner (906.060) after cleaning.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Novy 7810 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info