Bedienungsanleitung Novy 811-15 (Seite 16 von 24) (Deutsch, Englisch, Holländisch, Französisch)

654184

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

- Power supply: (2xAAA) batteries

- Frequence: 433.92Mhz

- Numbre of codes: 10

- Worktemperature: 0-50°C

- Dimensions: 110 x 50 x 19mm

Maintenance

Maintenance of the grease ﬁlter

The hood contains one metal ﬁlter which should

be cleaned twice a month.

Grease ﬁlter indication

After 20 cooking hours, the 4 speed indicator

lamps will start to blink during 5 minutes, this

indicates that the grease ﬁlter has to be cleaned.

When replacing the cleaned ﬁlter, you have to

reset the hood by pushing the – button during 5

seconds . If you don’t reset, the speed indicator

lamps will continu blinking.

Access to the ﬁlter

Take hold of the right and left side of the plate (a)

and pull down simultaneously.

Remove the ﬁlter (b) by taking hold of its hook and

pulling down.

Cleaning the ﬁlter:

• in the dishwasher

• manually: in a hot solution of water and a liquid

detergent. Rince and allow to dry completely

Important! The previous instructions need to

be followed. If not an increased ﬁre hazard may

occur.

Maintenance of the hood

Please allow the lights to cool down sufﬁciently

before cleaning the hood.

Use a soft, wet cloth and a mild detergent to clean

the hood.

Never use aggressive, abrasive detergents or

sponges. Bleach will damage stainless steel.

The stainless steel surfaces can be treated with

Novy Inoxcleaner (906.060) after cleaning.

Lighting

Press key ④ to switch the lighting on or off. The

LED lighting has a soft on/soft off mode, which

means that the lighting will evenly go on and off.

When switching on the lighting, this will always

light up with full power and it can also be used

when the fan is off.

Dimming LED lighting:

When the LED lighting has been switched on, it

can be dimmed by keeping key ④ pressed.

Programming the remote control

The remote control for hood and hob are

preinstalled and ready for use. Only when the

remote control needs to be reprogrammed

(interaction with other controls)act as in the

following.

Determine the code used:

Simultaneously press on/off + the key with the

sun. The lamp ﬂashes as well as the selected

code (there are 10 code options in total).

Change the code:

a. Simultaneously press on/off + the key with

the sun for 3 seconds until the lamp is ﬂash-

ing. After this the lamp as well as the selected

code will ﬂash. Repeat this step until you have

reached the required code (there are 10 code

options in total).

b. Simultaneously press + lamp of the roof cover

control until the second green speed indicator

lamp is blinking.

c. Press the key with the sun on the remote con-

trol within 10 seconds to conﬁrm the settings.

The cooker hood and the remote control are

now in line with each other.

Change the batteries:

• For changing the batteries unscrew the plastic

cover, remove the old batteries and insert the new

ones. Pay attention to the polarity marking given

in the battery compartment (ﬁgure 4).

• Empty batteries are not to be disposed of in the

household refuse, but they are to be handed in as

chemical waste.

NOVY key:

You can switch on the ambient lighting using the

NOVY key (ﬁgure 5).

Technical information:

EN 16

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Novy 811-15 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info