Bedienungsanleitung Nuna CariNext (Seite 11 von 205) (Alle Sprachen)

768539

Zoom out

Zoom in

Vorherige Seite

1/205

Nächste Seite

109CARI next instruction CARI next instruction

5 - After placing the base on the vehicle seat, extend the load leg to floor (8).

When the load leg is installed correctly, the load leg indicator will show

green. Red will be shown when installed incorrectly. (8)-2

The load leg has multiple positions. When the load leg indicator shows

red this means the load leg is in the wrong position.

Make sure the load leg is in full contact with the vehicle floor pan.

Squeeze the load leg adjustment button, then shorten the load leg

upwards. (8)-1

The completely assembled base is shown as (9).

The ISOFIX connectors must be attached and locked onto the ISOFIX

anchor bars. (9)-1

The load leg must be installed correctly with green indicator. (9)-2

Attaching Carry Cot to the Base

1 - Pull up the canopy as illustrated while pressing the buttons on both

sides. (10)

2 - Check to make sure the handle is secure before placing the child in the

carry cot. (11)-1

Make sure that the handle is in the correct position of use before carrying

or lifting.

3 - Push the carry cot down onto the base (12), if the carry cot is secure, the

shell indicator will show green. (13)

Please check that the mesh at the bottom of the carrycot is fixed properly

before installing carry cot. (12)

Check that the carry cot is locked onto the base by pulling up on the

handle.

4 - Press the ISOFIX adjustment and push the base back until it comes in

contact with the vehicle seat back.

5 - To release the carry cot, squeeze the infant carrier release button on the

base (14)-1, then lift the carry cot up. (14)-2

When carry cot is installed on base, the incorrect installation is shown in

(16). The correct installation is shown in (15)

Uninstalling the Base

1 - To remove the base, press the secondary lock button (17)-1 first followed

by the button (17)-2 on the ISOFIX connectors before removing the base

from the vehicle seat. (17)

2 - For transporting, press ISOFIX adjustment button and move the ISOFIX

connectors back into the storage position. (18)

Securing Child

1 - Open the carry cot cover. (19)

2 - Press the harness adjustment button while pulling the both shoulder

harnesses of the enhanced child restraint to the desired length. (20)

3 - Unlock the buckle by pressing the red button. (21)

We recommend using the infant insert while the baby is under 60cm and

until they outgrow the insert.

Remove the side wing of the infant insert when the baby's shoulders no

longer fit comfortably. (22)

4 - Place child into the enhanced child restraint and engage the buckle.

(23)(24)

5 - Tighten the shoulder harness straps by pulling the adjustment webbing.

(25)

Make sure the space between the child and the shoulder harness straps

is about the thickness of one hand.

6 - Attach the cover to the carry cot with the zippers on either sides. (26)

7 - To use the dream drape™, secure it to the two sides of carry cot with

magnets. (27)

8 - The canopy window can be opened for ventilation. (28)

Detach & Assemble Soft Goods

Follow steps (29) - (42) to detach soft goods.

To re-attach the soft goods please repeat the above steps in the reverse

step.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nuna CariNext Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info