Bedienungsanleitung Nuna Tres LX (Seite 12 von 98) (Alle Sprachen)

768530

Zoom out

Zoom in

Vorherige Seite

1/98

Nächste Seite

9TRES lx instructions TRES lx instructions

1 - While pressing the harness adjustment button, pull completely the two shoulder harnesses of the enhanced

child restraint. (17)

2 - Press the button to disengage the buckle. (18)

3 - Place the buckle tongues against the magnetic area on the outer side of the child restraint so that the

tongues are held in place. (19)

4 - Engage the buckle.

The green indicator shows that it has been buckled in place. (20)

5 - Pull the adjustment webbing toward you to adjust it to the proper length and make sure your child is snugly

secured. (21)

After the child is seated, recheck whether the shoulder harnesses are at the proper height.

Always keep child secured in harness and properly tightened by removing any slack.

Forward Facing Mode

(Child height 100cm-145cm)

Installation for Forward Facing Mode

When using in the forward facing mode, please remove the infant insert, and place the shoulder harness

straps, buckle and buckle tongues in the harness hideaway storage compartments.

Please adjust the shoulder harnesses to proper length before storing the shoulder straps and buckle in their

storage compartments.

Please adjust the enhanced child restraint to the desired recline position. (4 positions for forward facing

mode). Align the top reclining indicator with one of the bottom white numbers.

While using and adjusting the vehicle seat belt, check that there are no twists in the vehicle seat belt that

could cause your child fastened incorrectly.

Securing your Child in the Enhanced child restraint Use infant insert 1 - Press the button to disengage the buckle as (18).

2 - Remove Crotch Strap as shown in (37) and then the infant insert.

When installing the enhanced child restraint in the forward facing mode, do not use the infant insert.

3 - Detach the snaps. (22)-1

4 - Lift the upper flap upward and pull the lower flap forward, and then store the shoulder straps in their storage

compartments. (22)-2

5 - Pull the buckle to the back of the seat pad, and then store the buckle and buckle tongues in respective

storage compartments. (22)-3 (22)-4

6 - Reattach the snaps to recover the seat pad. The recovered seat pad is shown as (23).

Installing ISO Connector™ attachments

1 - Insert ISO Connector™ attachment guides to assist with installation. The ISO Connector™ attachment

guides can protect the surface of the vehicle seat from being torn. (24)

2 - Extend the ISO Connector™ attachments by pressing the adjustment button (25) and pulling out the

attachments. (26)

Make sure that both ISO Connector™ attachments are securely attached to their ISOFIX anchor points. The

colors of the indicators on both ISO Connector™ attachments should be completely green. (27)

The ISO Connector™ attachments must be attached and locked onto the ISOFIX anchor points.

Check to make sure the enhanced child restraint is securely installed by pulling on the both ISO Connector™

attachments.

3 - Press the ISO Connector™ adjustment button and push the enhanced child restraint back against the vehicle

seat until tight. (28)

Removing and storing ISO Connector™ attachments

1 - To remove from the vehicle, press the ISO Connector™ adjustment button (29)-1 and pull the base away

from the seat. (29)-2

2 - To release the ISO connectors from the vehicle's ISOFIX anchor points, press and hold the front button

(30-1), while you press the back one (30-2).

3 - To retract the ISO Connector™ attachments into the base press the ISO Connector™ adjustment button. (31)

Securing the child in the child restraint system

1 - Please check whether the vehicle shoulder belt guides are at proper height when the child is in the

enhanced child restraint.

2 - Position the shoulder belt through the shoulder belt guide and pass the lap belt through the vehicle lap belt

slots. Engage the vehicle buckle and pull the vehicle belt to make sure it is tightened. (32)(33)

Shoulder belt must pass through shoulder belt guide.

Lap belt must pass through lap belt slots.

NEVER use a 2-point vehicle belt (lap-belt only) to secure your child.

DO NOT use shoulder belt loose or positioned under arm.

DO NOT use shoulder belt behind child’s back.

DO NOT allow child to slide down in the enhanced child restraint in case of strangulation.

Detach the snaps

on the head

support to remove

the head portion of

the infant insert.

Remove the head support

portion of the infant insert

when the child’s

head no longer fits

comfortably.

Remove the body

portion of the infant insert

when the infant’s

shoulders no longer fit

comfortably.

Remove the infant insert

cushion by detaching the

snaps to allow more space

when the infant does not

fit comfortably. The

cushion can be used

separately without being

attached to the infant insert

to bolster the infant's back

for more comfort.

We recommend using

the full infant insert while

the baby is under 60cm

and can be used until

they outgrow the infant insert.

The infant insert increases

side impact protection.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nuna Tres LX Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info