• CAUTION! Friction from the rotating blade can cause ingredients
to heat and generate internal pressure in the sealed vessel. Do
not continuously operate for more than one minute. If the vessel
is warm to touch, allow it to cool before carefully opening it
pointed away from your body.
• Extract for no longer than 1 minute. If more extraction is needed,
wait 1 minute, then repeat the extraction process in 1 minute
intervals up to three times as needed to achieve the desired
consistency. If more than three 1-minute extractions are needed,
allow the Power Base to cool for 2-3 minutes after the third
extraction before beginning the next round.
• Never permit any blended mixture to sit inside a sealed vessel
without first releasing internal pressure.
• Do not allow blended mixtures to sit for long periods of time in
a sealed container. The sugars in the fruit and vegetables can
ferment, creating gas and causing pressure to build up and
expand in the vessel which can cause ingredients to burst and
spray out when moved or opened.
• Never use the NutriBullet Balance to blend ingredients without
adding liquid in as doing so may damage the blade.
• The cyclonic action of your NutriBullet Balance requires the use
of liquids to make NutriBlasts and other nutritious beverages. The
NutriBullet Balance is not intended to be used as an ice crusher,
and not without liquids. To make a delicious cold NutriBlast, we
suggest that you use frozen fruit and chilled liquids. Alternatively,
you may add crushed ice, up to 25% of the total cup volume, with
water or other liquid filled up to the “MAX” line. Do not crush ice or
other hard items without liquid, as such prolonged use over time
may dull or damage the blades. Always inspect your blades before
each use.
• To stop the motor, twist the cup to release it from the lock mode,
and at the same time, press the cup/blade assembly down and wait
for the motor to power down completely.
• Never remove the cup and blade assembly from the power base
until the motor comes to a complete stop. Removing the cup/
blade assembly while the power base is still running may cause
