Bedienungsanleitung Oase Biorb Classic (Seite 18 von 142) (Alle Sprachen)

693176

Zoom out

Zoom in

Vorherige Seite

1/142

Nächste Seite

- EN -

18 biOrb CLASSIC / FLOW / CUBE / LIFE / TUBE

Installing and connecting the aerator pump

NOTE

When installing the unit, ensure that it

• is located outside the aquarium

• is not placed on or over the aquarium

• cannot fall into the water or move out of position.

Damage resulting from incorrect installation is not ba-

sis for a claim within the framework of the guarantee

or warranty.

How to proceed:

 D

1. Connect the air hose leading out of the aquarium to

the air connection of the aerator pump and fit the

aerator pump above the subsequent level of the

aquarium water.

– This prevents water from leaking or damage to

the pump in case the integrated non-return valve

should fail.

2. Connect the connection cable of the aerator pump

to the separate socket of the plug-in transformer so

that it forms a drip loop.

– Always connect the aerator pump to the plug-in

transformer first, then connect the plug-in trans-

former to the power socket.

(→ Commissioning/start-up)

Connecting the lighting unit

• See the separately included operating manual.

COMMISSIONING/START-UP

Filling with and preparing the water

It is necessary to prepare the aquarium water by add-

ing "Water Conditioner" and "Biological Booster".

How to proceed:

 E, F

1. Fill the aquarium with 2 litres of tap water.

2. Insert the plug-in transformer into the socket to

switch on the aerator pump.

3. Fill the aquarium with more tap water up to about

5 cm below the cover.

4. Cut open the "Water Conditioner" bag and sprinkle

the contents into the water.

5. Once the pump has been running for at least 24 h,

sprinkle the contents of the "Biological Booster" bag

into the water.

Switching the aerator pump on/off

NOTE

Never operate the aerator pump by itself, i. e. without

the air hose and air stone connected.

How to proceed:

 F

Switching on: Connect plug-in transformer to the

socket. The unit switches on immediately when the

power connection is established.

Switching off: Disconnect the plug-in transformer.

Switching the lighting unit on/off

• See the separately included operating manual.

REMEDY OF FAULTS

Malfunction

Cause

Remedy

The water becomes soiled within a

short time.

The filter cartridge is exhausted.

Replace the filter cartridge.

Overfeeding

Reduce the amount of food.

Too many fish

Reduce the number of fish.

Aerator pump doesn't start up.

No mains voltage

• Check the connection of the aerator pump at

the transformer

• Check the mains voltage.

Aerator pump defective

Replace the aerator pump.

Aerator pump is noisy.

Aerator pump is vibrating.

Place the aerator pump onto a softer sur-

face.

Fewer air bubbles in the air tube than

normal

Air stone is exhausted.

Replace the air stone.

The aerator pump is noisy and there

are still fewer air bubbles even after

replacement of the air stone.

The aerator pump is only functioning to a

limited extent.

Replace the aerator pump immediately.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Oase Biorb Classic Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info