Bedienungsanleitung OK OBH 16311 (Seite 15 von 62) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch)

568770

Zoom out

Zoom in

Vorherige Seite

1/62

Nächste Seite

INTENDED USE

This product is designed for heating and cooking foods in suitable pans or pots. Any other use may result

in damage to product or injuries.

COMPONENTS

A. Hotplate 1500 W

B. Hotplate 1000 W

C. Hotplate 2000 W

D. Hotplate 1000 W

E. Control panel

F. Power indicator light

G. Temperature controls

H. Brackets

I. Screws

J. Sealing strip

BEFORE FIRST USE

• Remove the product and accessories from the original packaging carefully. For disposal of the original

packaging, follow applicable legal requirements. If you have questions about correct disposal, contact

your local authority.

• Check the package contents for completeness and damage. If the package content is incomplete or

damages can be found, contact your place of purchase immediately.

• After unpacking clean the product, see chapter Cleaning and care.

• During the production product parts (hot plate) are coated with a protective lm. To remove these

production residues, turn the thermostat up to the maximum position (level 6) and keep the product

in operation for about 3 minutes without pot/pan. Please ensure adequate ventilation, as this can lead

to slight odor and smoke which is harmless and will disappear after a short time.

INSTALLATION

For installation pay attention to all dimensions. Prepare a cutout of 490 x 560 mm into the work

plate.

WARNING! Pay attention to the safety clearances to the side and rear. When installing a hob higher

cabinets or room walls are only allowed with a 60 mm distance from the rear and 55 mm distance from

only one side (right or left). There shall be no higher cabinet or wall to the other side (right or left).

Pay attention to minimum clearances for air circulation inside the kitchen cabinet.

A (mm) B (mm) C (mm) D E

min. 650 min. 100 min. 20 Air inlet Air outlet min. 5mm

WARNING! If a hood is placed over the hob, the safety distance specied by the manufacturer must

be observed.

If no manufacturer's instructions are available or combustible materials (e.g. a wall unit) mounted

above the hob, the safety distance A must be at least 650 mm.

This appliance must be earthed.

Minimum requirement power cord: H05VV-F 3x6mm

/3x2.5mm

If possible connect the hob the mains before installing the hob to the work plate.

WARNING! Before connecting, all poles of the corresponding circuit must be disconnected from

mains supply.

The corresponding circuit shall be secured against unintentional reconnection.

The electrical connection must be done by an appropriately trained professional.

1. Remove the protective cap from the terminal.

2. Pay attention to the connection diagram and connect L, N and ground to the terminal

accordingly. Make sure that all cables are rmly xed.

3. Put the protective cap back on the terminal.

IM_OBH16311_140925_V03_HR.indb 15 25/9/14 5:57 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

OK OBH 16311 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info