Bedienungsanleitung OK OBH39831 (Seite 26 von 110) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch)

568780

Zoom out

Zoom in

Vorherige Seite

1/110

Nächste Seite

ADDITIONAL INFORMATION

Over-temperature protection

This appliance is equipped with a temperature sensor and automatic shutdown system to protect the induction hob from damage. The temperature

inside the induction hob is continuously monitored and the appliance will switch o automatically when a critical temperature is being measured.

Detection of small articles

When a cooking zone is switched on and a pot of unsuitable size, a non-magnetic pot (e.g. aluminium), or a small item (e.g. knife, fork, key) is detected on

the appliance, it automatically enters standby-mode after 1 minute. The fan will keep cooling down the appliance for a further 1 minute.

Automatic shutdown functions

• Shutdown function A: Cooking zones with a suitable pot still on it will be shut down after a certain amount of time has elapsed. The time until

shutdown depends on the heat level setting:

Power level Keep warm 1 2 3 4 5 6 7 8 9

Default working timer 2 8 hours 4 hours 2 hours

• Shutdown function B: When the pot is removed from the cooking zone but you forget to switch o the cooking zone the appliance stops heating

immediately. The hob automatically switches o after 2 minutes.

TROUBLESHOOTING

Problem / Error code display Possible Cause Solution

The cooktop cannot be turned on. No power. Make sure the cooktop is connected to the power

supply and that it is switched on.

Check the household fuse for the appliance. Check

whether there is a power cut by trying other electric

appliances.

The touch controls are unresponsive. The controls are locked. Unlock the controls ( Child lock).

The touch controls are dicult to

operate.

There may be a slight lm of water over the controls or

you may be using the tip of your nger when touching

the controls.

Make sure the touch control area is dry. Use the ball of

your nger when touching the controls.

Some pans make crackling or

clicking noises.

This may be caused by the construction of your

cookware (layers of dierent metals vibrating

dierently).

This is normal for cookware and does not indicate a

fault.

The induction hob makes a low

humming noise when used on a

high heat setting.

This is caused by the technology of induction cooking. This is normal, but the noise should quieten down or

disappear completely when you decrease the heat

setting.

Fan noise coming from the

induction hob.

A cooling fan built into your induction hob has come

on to prevent the electronics from overheating. It may

continue to run even after you’ve turned the induction

hob o.

This is normal and needs no action. Do not switch the

power to the induction hob o at the wall while the

fan is running.

Pan does not heat up and it does not

appear in the display.

The induction hob cannot detect the pan because it is

not suitable for induction cooking.

Use cookware suitable for induction cooking

( Choosing the right cookware).

The induction hob cannot detect the pan because it is

too small for the cooking zone or not properly centred

on it.

Centre the pan and make sure that its base matches

the size of the cooking zone.

Error code

Temperature sensor failure or other issue. Contact your retailer or a qualied technician.

Error code

Abnormal supply voltage. Inspect whether power supply is normal.

Power on after the power supply is normal.

Error code .

Abnormal temperature. Inspect the pot in use.

The hotplate has overheated and has switched o in

order to protect the hob.

Wait until the electronic system has cooled suciently.

Then, switch on again.

CARE AND MAINTENANCE

Warning!

Always switch o the electricity supply before performing maintenance work. In the event of a fault, contact an ocial distributor or authorised dealer.

• If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent.

• For domestic use only.

• Never place the induction hob directly into water.

• Never place an empty pan on the hob as this might cause damage to the pan. The over-temperature protection might cause an automatic shutdown

of the appliance.

• When a cooking zone has been on for a long time, the surface remains hot for some time afterwards so do not touch the glass surface.

• Occasionally check that nothing is obstructing the air inlet beneath the induction hob.

• If the surface of the hob is cracked, disconnect from power supply the appliance to avoid any possibility of electric shocks.

• Do not place rough or uneven vessels on the hob, as they could damage the glass surface.

• Avoid banging pots and pans down on the hob.

The glass surface is tough but not unbreakable.

• Do not leave metal objects, such as knives, forks, spoons and lids on the hob as they may get hot.

• Do not store detergents or ammable materials beneath the hob.

• Only clean the hob when it has cooled suciently.

• When the power to the cooktop is switched o, there will be no residual heat indication but the cooking zone may still be hot. Take extreme care!

IM_OBH39831_141028_V06.indb 26 10/28/14 2:44 PM

OK OBH39831 Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info