28
EN
RINSE AID DISPENSER
The rinse aid is released during the final rinse to prevent water from forming droplets on your dishes, which can leave
spots and streaks. It also improves drying by allowing water to roll off the dishes. Your dishwasher is designed to use
liquid rinse aids. The rinse aid dispenser is located inside the door next to the detergent dispenser. To fill the dispenser,
open the cap and pour the rinse aid into the dispenser until the level indicator turns completely
black. The volume of the rinse aid container is about 110ml.
FUNCTION OF RINSE AID
Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and spot and streak free drying.
ATTENTION!
Only use branded rinse aid for dishwasher. Never fill the rinse aid dispenser with any other substances (e.g. Dishwasher
cleaning agent, liquid detergent). This would damage the appliance.
WHEN TO REFILL THE RINSE AID DISPENSER
If there is no rinse-aid warning light in the control panel, you can estimate the amount from the colour of the optical
level indicator C located next to the cap. When the rinse-aid container is full, the whole indicator will be dark. As the
rinse-aid diminishes, the size of the dark dot decreases. You should never let the rinse aid level fall 1/4 full.
FILL THE RINS AID DISPENSER
As the rinse aid diminishes, the size of the black dot on
the rinse aid level indicator changes, as illustrated below.
Full
3/4 full
1/2 full
1/4 full - Should refill to eliminate spotting
Empty
To open the dispenser, turn the cap to the "open" (left) arrow and lift it out.1.
Pour the rinse aid into the dispenser, being careful not to overfill.2.
Replace the cap by inserting it aligned with "open" arrow and turning it to the closed (right) arrow.3.
Clean up any rinse aid spilled while during f illing with an absorbent cloth to avoid excessive foaming during the next
wash. Don't forget to replace the cap before you close dishwasher door.
NOTE:
ADJUSTING RINSE AID DISPENSER
The rinse aid dispenser has six or four settings. Always start with the
dispenser set on "4". If spots and poor drying are a problem, increase the
amount of rinse aid dispensed by removing the dispenser lid and rotating the
dial to "5". If the dishes still are not drying properly or are show spots, adjust
the dial to the next higher lever until your dishes are spot-free. The
recommended setting is "4". (Factory value is "4".)
Increase the dose if there are drops of water or lime spots on the dishes after washing. Reduce it if there are sticky
whitish stains on your dishes or a bluish film on glassware or knife blades.
NOTE:
Adjust lever
(Rinse)
C Rinse Aid Indicator
