Bedienungsanleitung OK OFK 411 D (Seite 21 von 123) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch)

783041

Zoom out

Zoom in

Vorherige Seite

1/123

Nächste Seite

Mounting the door

Caution!

After you have placed the refrigerator upright on its feet, wait for 2 hours

before you connect it to the mains to permit the cooling system to regain

full capacity.

1. Place the freezer door on the lower hinge. Flip the middle hinge over, insert the

bolt into the hole on the top of the freezer door, and screw the hinge in place.

Two plastic washers must sit on the bottom and one on top of the bolt. The pad

between the hinge plate and the refrigerator must also be attached. The freezer

door is now ﬁxed. Check for correct function and ﬁtting.

2. Remove the hinge pin counterpart with the door stop at the bottom of the

refrigerator door. Attach the supplied hinge pin counterpart with door stop to

the opposite side. Remove the blind cap on the top of the refrigerator door and

insert it into the hole on the opposite side.

3. Place the hole on the left side of the refrigerator door onto the middle hinge

pin and hold the door ﬁrmly. Insert the bolt of the upper hinge plate into the

designated left hole on the top of the refrigerator door. Screw the upper hinge

plate to the refrigerator. Check the correct function and the correct ﬁt.

4. Clip the cover cap onto the upper hinge plate.

5. Attach the cap of the left side to the right side.

ENERGY SAVING TIPS

• Do not place the product in the vicinity of a heat source (radiator or kitchen

stove, etc.).

• Ensure unobstructed air ﬂow around the refrigerator and freezer.

• If a layer of ice has built, defrost the unit. A thick layer of ice aects the

transmission of the cold, thus the energy consumption will be increased.

• When opening the door and taking out food, only open the door shortly. A

shorter door opening time causes less ice to deposit on the freezer walls.

• Select the temperature regulator setting according to the ﬁlling amount of the

product.

• Use drawers, baskets or shelves to store the food. If the energy of the product is

used eciently, the energy consumption can be minimized.

• It’s advised not to remove all accessories, such as drawers, shelves balconies, as

this might increase the energy consumption.

CLEANING AND CARE

Warning!

• Unplug the product before cleaning.

• When cleaning, never use solvents or abrasive materials, hard brushes, metallic or

sharp objects. Solvents are harmful to human health and can attack plastic parts,

while abrasive cleaning materials and tools may scratch the surface(s).

• Never use oil or grease on the door seal. This will make it porous over time.

• Do not use steam cleaning equipment. The steam may come in contact with

electrical parts of the product, causing a short circuit.

• Clean the product’s exterior surfaces with a slightly damp cloth and then dry

them thoroughly.

• Make sure that no water enters the product interior (for example, through the

switch).

IM_OFK411D_210126_V09_HR.indb 21IM_OFK411D_210126_V09_HR.indb 21 26/1/2021 09:4126/1/2021 09:41

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

OK OFK 411 D Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info