Bedienungsanleitung OK OFK34411 A3 (Seite 16 von 99) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch)

783040

Zoom out

Zoom in

Vorherige Seite

1/99

Nächste Seite

Size = A5

OPERATION

Fig. 4 Plug in the power plug into an appropriate mains socket outlet.

Note: Allow the product to precool for about 2-3 hours before storing food in it.

Setting the refrigerator temperature

Fig. 5 Set the temperature with the temperature control.

Levels 1-7 do not correspond to any particular temperature. In position 0 the appliance is

switched o. The lower the setting, the higher the inner temperature.

Note:

• To check the temperature, insert a commercially available thermometer into the device.

• The temperature in the unit depends on the ambient temperature and the setting of the

temperature controller.

• Make sure the door of the product is properly closed and not blocked by food.

Replace the light bulb

Warning! Disconnect the power plug before replacing the light bulb.

Fig. 6 To change the light bulb of the interior lighting, rst remove the screw and then the cover.

Unscrew the defective bulb and replace it with an equivalent model E14-5 (max. 10 W). Install

cover and screw again.

ADJUST THE SIDES OF THE DOORS

Note:

• If necessary, and if the premises require it, the mounting of the doors can be changed. To do this,

follow all the following instructions in the given order.

• The following tools are required:

10 mm wrench and Phillips screwdriver. Due to the uniqueness of the appropriate tools, those are not

mentioned separately in the following instructions.

• For this work a dierent cover is needed, which is provided with the unit.

• For safety, remove the door trays to prevent them from being damaged.

Top door

35. Remove the four caps in the upper plastic cover and unscrew all four screws. Remove the

plastic cover. Store all parts safely. Unscrew the upper hinge plate. When unscrewing, be sure to hold

the refrigerator door rmly, otherwise it will be damaged.

36. Pull out the door and place it on a soft and clean surface.

Bottom door

1. Hold the freezer door and remove the two screws on the middle hinge.

2. Pull the freezer door upwards and place it on a soft and clean surface.

3. Remove the two blind caps above the freezer compartment and the blind plug on the top of the

freezer door and insert them into the holes on the opposite sides.

Refrigerator bottom

Caution! Pull out the mains plug!

1. Tilt the refrigerator so you can work at the bottom or place the refrigerator fully on its back. Make sure

the back is placed on a soft and clean surface. Unscrew the feet on both sides using a hex-wrench.

Loosen the screws and remove lower hinge plate.

2. Remove the door hinge bolt, turn the hinge plate over and screw the door hinge pin in the same hole

from the other side.

3. Attach the turned hinge plate onto the left side by screws. Screw the feet into the plates on both sides.

Place the refrigerator back on its feet and adjust them if necessary.

IM_OFK34411-A3_190520_V06_HR.indb 16 20/5/2019 16:35

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

OK OFK34411 A3 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info