773004
4
Zoom out
Zoom in
Vorherige Seite
1/8
Nächste Seite
Chapter 6 Child’s bicycle seat OKBABY ORION Page 73
Instructions for use and assembly LIB003R03 Edition: 05-2005
- the child’s seat does not cause any
particular difficulties whilst pedalling.
If any of these situations arises, refer to
illustrations 4 and 5 on the previous page.
Illustration 4:
Loosen the fixing nuts under the seat and
move it frontward or backwards as
required, tightening the nuts again.
Illustration 5:
Compatibly with the height of the crossbar
of your bicycle, you can also move the
fixing block upwards or downwards,
loosening the four screws (9), and then
tighten them again after having found the
most satisfactory position. Tighten the
screws (9) gradually and evenly until the
fixing block no longer rotates around the
frame. Avoid excessive tightening of the
screws.
Illustration 7:
To extract the child’s seat from the fixing
block, push the two safety springs 15
inwards whilst sliding the support arm out
of the holes.
DANGER! Always check that the
bicycle handlebar does not remain caught
in the child’s seat whilst steering.
Illustration 8:
Insert the footrests (4) with the respective
belt in the relative housings.
ATTENTION! Take care to insert
the correct footrest in its housing, bearing
in mind that there is one footrest for the
right foot and one for the left foot.
Instructions for use and assembly LIB003R03 Edition: 05-2005
Chapter 6 Child’s bicycle seat OKBABY ORION Page 72
Illustration 4:
After having positioned the support arm,
with the screws loose, in one of the three
possible positions (usually the
intermediate one is the most commonly
used) tighten the nuts with the wrench
(14) supplied until completely fixed.
Illustration 5:
Choose the plastic reducers (11) suitable
to the diameter of the crossbar of your
bicycle. Insert the reducers (11) into the
fixing block (7) and the fixing counter-
block (8). Assemble the fixing block (7)
with the fixing counter-block (8) using the
four screws (9) with their respective
washers and nuts. Leave the screws (9)
slightly loose in order to be able to
proceed with any adjustments in height
and in rotation.
The support must only be placed in the
direction of travel as shown in
illustration 6.
Illustration 6:
Take the seat and insert the ends of the
support arm (6). in the two holes 16 on
the fixing block. Check that the support
arm is in place by means of the special
stops on it and that the two safety springs
15, on the two sides of the fixing block,
are inserted in the appropriate housings
on the support arm. At this stage, check
that:
- the handlebar interferes as little as
possible with the seat and allows you to
steer normally;
11
78
9
15
16
4
14
11
15 15
ENGLISH
ENGLISH
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Okbaby Orion wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Okbaby Orion

Okbaby Orion Bedienungsanleitung - Alle Sprachen - 51 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info