Bedienungsanleitung Olimpia Splendid Caldo Crystal (Seite 36 von 124) (Deutsch, Englisch, Französisch, Italienisch, Spanisch)

703021

Zoom out

Zoom in

Vorherige Seite

1/124

Nächste Seite

ENGLISH

EN - 10

6 - APPLIANCE INSTALLATION

6.1 - Wall installation

After removing the packaging, make sure of the appliance integrity; in case of doubts,

do not use it and please refer to professionally qualied personnel.

The appliance must be installed on a masonry or made of heat resistant material wall

(not wooden or made of easily overheatable synthetic material).

For the correct installation, work as follows:

The appliance must be installed:

• in such a way as to prevent the ON/OFF switch and the buttons

from being touched by who is standing in the bathtub or in the

shower.

• At a distance of at least 300 mm from walls

• At a distance of at least 1000 mm from ammable materials (cur-

tains, textiles etc.)

DO NOT install the appliance beneath power outlets.

Prepare a power outlet in the vicinity of the appliance making sure

it’s not too far in relation to the power cord length (gure C).

a. Locate the area where the appliance is going to be installed.

b. Create two due 6mm holes with a centres distance of 494mm (gure D).

The holes must be at least 2000mm away from the oor 350mm

from the ceiling (gure D).

When piercing the wall, make sure that no electrical channels or

water hoses are present.

c. Insert the wall plugs in the holes and then fasten the supplied screws.

d. Do not fasten the screws entirely; leave them approximately 10 mm away from

the wall (gure E).

Make sure that the screws are well steady in the wall

e. Place the slots (X) on the rear part of the appliance on the screws pushing the

appliance itself against the wall (gure F - phase 1).

f. Push the appliance 10 mm towards the left (gure F - phase 2) then push it about

8÷10mm downwards (gure F - phase 3).

g. Lastly, check that the appliance is steady and well attached to the wall.

6.2 - Electrical connection

• Before connecting the appliance plug to the power outlet, make

sure that the voltage values indicated on the data plate corre-

spond to the mains supply ones and that the outlet is equipped

with an ecient grounding.

• In case of incompatibility between the outlet and the plug of the

appliance, let the outlet be replaced with another one of the suit-

able type by professionally qualied personnel, which verify that

the outlet cables section is suitable for the power absorbed by

the appliance. Generally, it’s not advised to use adapters and/

or extension cords; if their use should become essential, they

must comply with the current safety standards and their current

capacity (A) mustn’t be lower than the appliance maximum one.

• The socket must be easily accessible so that the plug can be

removed easily in an emergency.

a. Insert the plug in the power outlet.

b. Press “I” (ON) on the switch (7); the appliance is ready for use.

This product has a ap that opens automatically when the product

is turned on and closes automatically when turned o.

- Do not move the ap with your hands. -

As this could damage or deform the unit. Open the ap with your

hands only if it accidentally closes in part or in whole.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Olimpia Splendid Caldo Crystal Seite 36

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info