Bedienungsanleitung Olivetti ECR 2450T (Seite 11 von 81) (Englisch)

452059

Zoom out

Zoom in

Vorherige Seite

1/81

Nächste Seite

ENGLISH

Unpacking and Setting Up the Cash Register

NOTE: Please read this section carefully before attempting to program

the cash register or perform sales transactions.

As soon as you receive the cash register, open its shipping carton and

carefully withdraw each component. Make sure that the cash register

and all of its accessories, listed in the section entitled Standard

Accessories, are present in order to setup the cash register by following

these guidelines:

1. Place the cash register on a level, stable, vibration-free and dust-

free surface. Make sure that it is near a grounded power outlet.

2. Plug the cash register into a grounded power outlet.

3. Insert the batteries as explained in the section entitied Inserting/

Replacing Batteries. Do not insert the batteries unless the cash

WARNING: Before inserting the memory backup batteries, make

sure that the cash register is plugged into an electrical

power outlet. The machine must be plugged into an

electrical outlet before you insert the batteries.

4. Load the thermal paper roll as explained in the section entitled

Loading Thermal Paper.

5. Set the desired program options as explained in the section Cash

6. Once the desired program options have been set, turn the control

key to the REG 1 or REG 2 position and you are ready to perform

sales transactions. In the REG 2 position the cash register will not

print the programmed receipt header.

Maintaining the Cash Register

Provided below is information on how to maintain your cash register.

NOTE: Before cleaning the cash register, make sure it is powered off

and/or unplugged from the wall outlet. Before unplugging the

cash register from the wall outlet, make sure that four charged

AA standard backup batteries are installed in the battery

compartment. All data stored in memory will be cancelled if

you unplug the cash register from the electrical wall outlet

without back-up battery supply.

1. Keep all liquids away from the cash register so as to avoid spills

which could damage the electronic components.

2. To clean the cash register firstly turn it off and/or unplug it from the

wall outlet (be sure the back-up batteries are installed), then use

just a damp cloth. Do not use corrosive substances such as solvents,

alcohol, petrol, or abrasive components.

3. If the cash register is stored in extreme hot or cold temperatures

(below 32 degrees or above 104 degrees Fahrenheit), allow the

temperature inside the cash register to reach room temperature

before turning it on.

4. DO NOT attempt to pull the paper tape when the cash register is

printing or when you are loading paper. Always use the [Feed] key

to feed paper. Pulling the paper tape could damage the print

mechanism.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Olivetti ECR 2450T Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info