812264
64
Zoom out
Zoom in
Vorherige Seite
1/160
Nächste Seite
Installation instructions
for the specialist company
LEVANA 2.0 6 kW
LEVANA 2.0 8 kW
LEVANA AQUA 2.0
ARINA 2.0
INARA 2.0
EN
Installation of a combustion air damper for automatic opening
and closing of the combustion air line (optional)
A closed combustion air line prevents warm air from escaping from
the installation room unnecessarily with the stove turned o.
Note! The combustion air damper is closed in the “O operat-
ing state. It is open in all other operating states (“Ready”, “Ignition,
“Start, etc.).
The actuator takes approx. 2 minutes to reach the closed” posi-
tion, i.e. the pellet replace may be switched o at the master
switch 2 minutes after “O appears on the display at the earliest.
The user of the pellet replace should also be informed of this
.
1
2
6
7
5 4 3 2
Fig. 2.20 Connection of a motor-driven combustion air damper
1Motor slewing ring
2Stops for the combustion air damper (open/closed)
3“S19” connector
4“L continuous” connector (must be connected to the
“L continuous” mating connector in the wiring harness)
5“S5” connector
6Combustion air damper screwed onto the rear
7Combustion air damper screwed onto the bottom
If other accessories are installed in addition to the automatic, mo-
tor-driven combustion air damper, take care to ensure, for reasons
of accessibility, that the combustion air damper is installed rst.
For the same reason, the side walls should also be installed rst
after installing the combustion air damper!
Connect the combustion air damper connector into the wiring
harness and to the main circuit board of the pellet replace as fol-
lows before installing the combustion air damper:
a) Plug the “19” connector into position “S19” on the main circuit
board (see connection diagram!)
b) Plug the “S5” connector into position “S5” on the main circuit
board.
c) Plug the “L continuous” connector into the “L continuous” con-
nector in the pellet replace wiring harness!
Follow a similar procedure to that which is set out in the “Conversion
of combustion air nozzles for connection from the bottom chapter:
Remove the lower back wall and panel!
Release the hose clamp on the combustion air line!
Remove the combustion air nozzles!
Plug the connecting piece for the combustion air damper into the
combustion air line and tighten the hose clamp again!
Screw the combustion air damper onto the rear or bottom of the
pellet replace!
311x
Fig. 2.21 Remove the lower back wall and panel
64
We reserve the right to make technical changes
78-4643-2481_R6_LEVANA 2.0_ARINA 2.0_INARA 2.0_DE-EN-FR.indd 6478-4643-2481_R6_LEVANA 2.0_ARINA 2.0_INARA 2.0_DE-EN-FR.indd 64 11.04.2023 14:41:4711.04.2023 14:41:47
64

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Olsberg ARINA 2.0 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info