Bedienungsanleitung Olsberg Merapi (Seite 14 von 40) (Deutsch, Englisch, Holländisch, Französisch, Spanisch)

812276

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

Operation

Permissible fuels

The following fuels are approved:

●Natural shopped wood in the form of billet wood

Maximum length: ..............33 cm

Circumference: ....approx. 30 cm

Billet wood reaches a moisture content of 10 to 15%

after being stored outdoors for 2 to 3 years (only cov-

ered at the top) and is then ideally suited for heating.

Freshly cut wood has a very high moisture content

and so burns badly. Apart from the very low calorif-

ic value it is also harmful for the environment. The in-

creased condensate and tar formation can lead to re-

place and chimney sooting.

This diagram shows that the consumption rate with

freshly-felled wood (caloric value 2.3 kWh/kg) is al-

most twice as high as the consumption rate with dry

wood (caloric value 4.3 kWh/kg).

Moisture [%]

dry wood that has been stored for at least 2 years

Caloric value [kWh/kg]

freshly-felled wood

You will only achieve optimum combustion and heat

in an environmentally friendly way with these fuels.

Adding the fuel in small quantities avoids unnecessary

emissions. Clean burning can be identied by the fact

that the rebrick becomes a light colour.

According to the German Federal Immission Control

Act, it is forbidden e.g. to burn the following fuels in

stoves:

●Moist wood or wood treated with wood

preservatives

●Sawdust, chippings, grinding dust

●Bark and chipboard waste

●Slack coal

●Other wastes

●Paper and cardboard (except for igniting)

●Straw

Please note before heating for the rst time

Locking hook in OPEN position

●When opening the combustion chamber door, the

locking hook automatically retracts and is held by

a spring in the OPEN position. If the locking hook

is unintentionally activated when the combustion

chamber door is open, it must be manually returned

to the OPEN position before the combustion cham-

ber door can be closed.

●Remove all accessories from the ash pan and com-

bustion chamber.

●The odour given off by the evaporation of the pro-

tective coating disappears after the stove has been

burning for several hours (ventilate the room well).

●The stove has a high quality temperature resistant

coat, which does not achieve its nal strength un-

til the stove has been heated for the rst time. You

should therefore never leave anything on the stove

and not touch the surfaces as the paint coat could

otherwise be damaged.

●As soon as the kindling material has burned down,

put on 2 burnouts consisting of 3 kg wood ensuring

that the temperature resistant coating reaches its -

nal rmness.

●Attention: The storage of fuel below the combus-

tion chamber door, before the lower front

shield (Fig.3, Pos.8) is prohibited.

Igniting

● Before ignition, check that no ammable objects are

placed on the stove.

●Empty the ash pan if necessary and slide back in.

●Open the combustion air slide valve complete.

●Grate in open position = operating lever pulled out

●Place the ignition material (ignition cubes and dry,

smaller ignition wood) and ignite it.

●Close the door to the combustion chamber so that

the kindling material can catch re.

●As soon as the igniting material is burning, add a

quantity of fuel corresponding with the required heat

(see chapter “heating”).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Olsberg Merapi Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info