Bedienungsanleitung Olsberg Pular Compact (Seite 14 von 36) (Deutsch, Englisch, Holländisch, Französisch)

707628

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Technical Data

● Nominal thermal output ................................................5,0 kW

● Room heat output ......................................................... 5,58 kW

● Connection pipe........................................................Ø 150 mm

● max. Weight ........................................................................150 kg

● Connection combustion air ..................................Ø 125 mm

● Operating mode .................................. Intermitting burning

Regulations to be observed

● Local and building law regulations

● The stove must be installed by a professional and con-

nected to the chimney. The specic national regulations

for safe installation of the connector must be complied

with. The connecting piece used must possess an open-

ing for cleaning.

● The stove must be regularly checked by a professional.

● The stove has national technical approval from the

Deutsches Institut für Bautechnik (DIBt) (German

Institute for Civil Engineering) for room-air independ-

ent operation.

Due to its general technical approval, the stove can be

used simultaneously with an approved ventilation sys-

tem without additional safety device.

Equipped with a self-closing combustion chamber door,

the stove is approved to be connected to multi-ue chim-

neys provided that it operates with a room-air dependent

combustion-air supply.

Room-air independent operation requires that the exhaust

gases of the replace be discharged through a single-ue

chimney or the exhaust duct of a single-ue air-exhaust

chimney. Exhaust gases may also be discharged into multi-

ue exhaust gas systems if all connected replaces are part

of the same utilisation unit/action range of the ventilation

system. Individual dierences can be discussed with your

district master chimney sweep.

Chimney design

The chimney design is according to DIN EN 13384 -1 and

-2 or to the specic national regulations.

The chimney must comply with the temperature class

T400.

Necessary data

Closed operation

with billet wood / wood briquettes:

● Nominal thermal output ......................................5,0 / 5,0 kW

● Waste air mass ow rate .................................. 3,76 / 3,67 g/s

● Waste air temperature at

connection duct .....................................................328 / 286 °C

● Minimum delivery pressure at

nominal thermal output ...........................................12 / 11 Pa

Combustion air supply

The stove can be operated conventionally, dependent on

the ambient air as well as independent of the ambient air.

It must be guaranteed that there is enough combustion air

available for the stove. For the proper function of the stove,

a necessary combustion air volume current of 10,5m³/h

must be considered.

Ambient air independent

combustion air connection

By an ambient air independent operating mode, the com-

bustion air must be added from outside through a leak-

proof line or through a supply duct in the chimney. Thus,

speak with your district chimney sweep master.

Due to energy saving reasons, the combustion air inlet

should be able to be blocked if the stove is not being op-

erated. This can occur through a shut-o valve in the com-

bustion air line or through the air slide valves on the stove.

If a shut-o valve is used, this must be clearly identied

with CLOSED/OPEN.

Through the shuto, it is avoided that heat is removed

from the set-up room through the constant circulation of

cold combustion air and cold combustion air lines may

lead to an increased formation of condensation.

Attention:

The combustion air line may not be closed during

operation!

In order to feed the combustion air to the stove externally

via a pipe instead of from the room in which it is installed,

it is possible to screw a Ø 125 mm combustion air pipe to

the back of the stove or at the bottom. If the combustion

air pipe installed is longer than 3 m, calculations will have

to be carried out to verify an adequate supply of combus-

tion air. At extremely low outdoor temperatures, conden-

sation can occur on the combustion air duct. For this rea-

son it must be insulated with a suitable insulating materi-

al. Observe the rules of the oven and air heating construc-

tion craft.

Use the Olsberg combustion air pipes with sealing lip.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Olsberg Pular Compact Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info